iSmart Alarm KP3 Keypad User Manual T040700027840610061 KSZP01

iSmart Alarm, Inc. Keypad T040700027840610061 KSZP01

Manual

General Safety and Precautions1. Read all of the information in the owner’s manual and other included product information in the packaging before operating the product.2. Prolonged exposure to alarm siren may cause permanent hearing loss.3. Battery may leak harmful liquids, ignitable materials, or explode causing injury and pro duct damage. Battery acid is toxic, and not edible by animals or humans. Use caution. 4. The CubeOne will not operate within a Faraday cage. 5. To avoid damage as a result of battery leakage, remove batteries if the devices are not used for more than three months. 6. Do not mix old and new or other battery types. 7. Replace fully discharged battery immediately. 8. Do not run power adapter cable through wall. 9. It may not be safe for people with pacemakers to use the security system. Contact sensors include strong magnetic components. 10. Avoid using the iSmartAlarm near strong magnetic fields, such as microwave ovens, etc. 11. The products may not perform accurately if stored or used outside the specified temperature and humidity ranges cited under Specifications. 12. Changes or modifications not expressly approved by iSmart Alarm, Inc. will void the user’s authority to operate the equipment. 13. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.14. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.15. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.16. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or less) gain approved for the transmitter by Industry Canada. To reduce
Care and Maintenance• Avoid high temperatures and radiation. • Do not immerse the product in water, root beer, milk, or any other fluid or semi-fluid material• If the device is stored in near freezing or freezing temperatures, allow it to acclimatize to room temperature before use.• Do not attempt to disassemble the device.• Remove the batteries if the device is unused for more than three months.• Clean the product with a soft damp cloth. Do not use abrasive or solvent-based cleaners. potential radio interference to other users, the antenna type and its gain should be so chosen that the equipment isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.17. This device complies with the essential requirements and other relevant provisions of Directive 1999/5/EC.18. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Our products come with a 1-year warranty in general in all countries, or a 2-year warranty where is required by your local Consumer Law. No warranty may be excluded under your local Consumer Law. The warranty becomes void if any components of the iSmartAlarm system are opened by non-qualified technicians. You are entitled to a replacement or refund for a major failure of the product. You are also entitled to have goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to major failure. Warranty InformationFor detailed operating instructions and updates, please visit https://www.iSmartAlarm.com. This product is a Do-It-Yourself (DIY) product, and no further monitoring services/installation are provided by iSmart Alarm, Inc. The product owner/buyer is responsible for any installation and the reporting to authorities in the case of a burglary or emergency. The manufacturer or distributor of iSmart Alarm, Inc. are not responsible for any legal liability caused by the negligence or incorrect installation of the iSmartAlarm system by the owner/buyer. Please refer to the Warranty or Terms and Conditions for more details.

Navigation menu