Wilson Electronics 460035 Quint Band Bi-Directional Direct Contact Coupling Amplifier User Manual Revised

Wilson Electronics, LLC Quint Band Bi-Directional Direct Contact Coupling Amplifier Users Manual Revised

Users Manual Revised

User ManualVehicle Signal Booster KitDRIVE SLEEKA WILSON ELECTRONICS BRANDNEED HELP? support.weboost.com 866.294.1660
______IndexPackage Contents 1 STEP 1: Mount Outside Antenna 2 STEP 2: Route & Connect Booster 3 STEP 3: Route Cable To Front Of Vehicle 5 STEP 4: Connect System To Power 6 STEP 5: Insert Phone Into Cradle 7Light Patterns 8Troubleshooting 9Safety Guidelines 11Specifications 12Warranty 14
DRIVE SLEEK CELL PHONE SIGNAL BOOSTER 1________Package ContentsSleekCradleOutside AntennaSignalBoosterPowerSupplyMagneticVent Mount(for cradle)
2CELL PHONE SIGNAL BOOSTER DRIVE SLEEK______Step 1: Mount Outside Magnetic AntennaNOTE: For roofs that are not metallic, use the included metal disk by peeling away the adhesive cover and sticking on the clean surface. 6 in. away from windows(including sunroofs)WORKS WITH ALL VEHICLES Identify a location on the top of your vehicle that is:  Near the center of the roof  At least 12 inches away from any other antennas  At least 6 inches away from any windows (including sunroofs) Cle an the surface where you will place the outside antenna. Mount the outside antenna.
DRIVE SLEEK CELL PHONE SIGNAL BOOSTER 3______Step 2: Route & ConnectBoosterRoute the cable into the vehicle. See examples below. NOTE: The cable is strong enough that it may be shut in most vehicle doors without damaging the cable. Car/Sedan: Cable routed into rear side door.SUV/Van/Hatchback: Cable routed into top of hatchback door.Truck: Cable routed into side door. Identify a location on the top of your vehicle that is:  Near the center of the roof  At least 12 inches away from any other antennas  At least 6 inches away from any windows (including sunroofs) Cle an the surface where you will place the outside antenna. Mount the outside antenna.
4CELL PHONE SIGNAL BOOSTER DRIVE SLEEK______(STEP 2 cont.)Connect the cable from the outside antenna to the booster port labeled ANTENNAby simply pressing the connector in until you hear a “click”.ANTENNAcable fromoutside antennabooster
DRIVE SLEEK CELL PHONE SIGNAL BOOSTER 5______Step 3: Route Cable To Front Of Vehicle We recommend routing the 15ft. fixed cable from the booster, under mats and between seats up to the front of the vehicle where the cradle will be located.Connect booster cable to cable from cradle.to front ofvehiclesnap-inconnectorscradle
6CELL PHONE SIGNAL BOOSTER DRIVE SLEEK______Step 4: Connect System To PowerConnect the power to the 12V CLA port on your vehicle and route power cable back to the booster.Connect power cable to booster port labeled .NOTE: We recommend routing with the same path as the cable going up to the cradle (under mats and between seats).NOTE: The booster will be on whenever there is power from the 12V CLA port. If your vehicle always has power going to this port, you may want to unplug this when you’re not driving so the booster does not drain your battery.ANTENNAconnect power supplyto 12V portconnectto booster
DRIVE SLEEK CELL PHONE SIGNAL BOOSTER 7______Step 5: Insert Your Phone Into CradleMake sure you have plenty of slack in the cable going up to the cradle (velcro straps included to manage excess cable). Insert your phone into cradle and watch your signal increase! NOTE: Magnetic vent mount included to mount the cradle to your dash.connectto boostercradle extendsinsert phone intocradle to boost signalmagnetic vent mount
8CELL PHONE SIGNAL BOOSTER DRIVE SLEEK______Light Patterns Solid WhiteThis indicates that your booster is functioning properly and at maximum gain.Light O Needs power.NEED HELP? support.weboost.com 866.294.1660
DRIVE SLEEK CELL PHONE SIGNAL BOOSTER 9FREQUENTLY ASKED QUESTIONS What hours can I contact customer support?Customer Support can be reached monday thru friday by calling 866.294.1660, or through our support site at support.weboost.com.Why do I need to create distance between the booster and the antenna?Antennas connected to a booster create spheres of signal. When these spheres overlap, a condition called oscillation occurs. Oscillation can be thought of as noise, which causes the booster to shut down to prevent damage. The best way to keep these spheres of signal from overlapping is to maximize separation between the Booster and Antenna.______Troubleshooting FIXING BLINKING LIGHT ISSUES123Make sure all connections are tight. Increase the distance between the outside antenna and cradle, by moving them horizontally and/or vertically farther apart until the light change to green. Remember to keep the antenna at least 6 inches from any window or sunroof.Reset system by disconnecting and reconnecting the power supply. If you are having any diculties while testing or installing your booster, contact our weBoost Customer Support team for assistance (866.294.1660).4NEED HELP? support.weboost.com 866.294.1660
10 CELL PHONE SIGNAL BOOSTER DRIVE SLEEK______Antenna Kit Options MOBILEOutside Antenna OptionsMini-Mag301126 w/ 12.5 RG174 cable - SMA301113 w/ 12.5 RG174 cable - FME12” Mag Mount w/12.5’ RG58301103311125311128314202 311703Trucker Antenna w/10.5’ RG583111013117014G Trucker Antenna w/13.5’ RG583111193111334G Trucker Antenna w/15’ RG58304415304414Marine Antenna w/10’ RG58311130-5810Marine Antenna w/20’ RG58304420Glass Mount w/14’ RG58311102NMO Antenna w/RG174Kit 311104-17410 800/1900 NMO Antenna 10’ RG174 CableKit 311112-17410 800/1900 NMO Antenna 10’ RG174 CableKit 314203-17410 800/900/1900 NMO Antenna 10’ RG174 CableNMO Antenna w/RG58Kit 311104-5810 800/1900 NMO Antenna 10’ RG58 CableKit 311112-5810 800/1900 NMO Antenna 10’ RG58 CableKit 314203-5810 800/900/1900 NMO Antenna 10’ RG58 Cable
DRIVE SLEEK CELL PHONE SIGNAL BOOSTER 11______Safety Guidelines Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment.Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell phone.Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment. The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less than 150 degrees Fahrenheit). It is not intended for use in attics or similar locations subject to temperatures in excess of that range.The outside antenna must be installed no higher than 10 meters (32’9”) above ground.Any antenna used with this device must be located at least 8 inches from all persons.FCC requires to never use the cell phone in the cradle next to your ear.FOR MORE INFORMATION ON REGISTERING YOUR SIGNAL BOOSTER WITH YOUR WIRELESS PROVIDER, PLEASE SEE BELOW: Sprint: http://www.sprint.com/legal/fcc_boosters.html T-Mobile/MetroPCS: https://support.t-mobile.com/docs/DOC-9827 Verizon Wireless: http://www.verizonwireless.com/wcms/consumer/register-signal-booster.html AT&T: https://securec45.securewebsession.com/attsignalbooster.com/ U.S. Cellular: http://www.uscellular.com/uscellular/support/fcc-booster-registration.jspThis is a CONSUMER device.BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider.In Canada, BEFORE USE you must meet all requirements set out in ISED CPC-2-1-05. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from (i.e., MUST NOT be installed within 20 cm of) any person.You MUST cease operating this device immediately if requested by the FCC (or ISED in Canada) or licensed wireless service provider.WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.ISED CPC-2-1-05: http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08942.html
12 CELL PHONE SIGNAL BOOSTER DRIVE SLEEKDrive SleekModel Number 460035FCC ID: PWO460035IC: 4726A-460035Frequency 698-716 MHz, 729-746 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHzMaximum PowerPower output for single cell phone (Uplink) dBm700 MHz Band 12/1718.74700 MHz Band 1321.57800 MHz Band 522.651700 MHzBand 4 25.561900 MHz Band 219.19Power output for single cell phone (Downlink) dBm700 MHz Band 12/172.1700 MHz Band 132.1800 MHz Band 5-2.52100 MHzBand 4 -0.61900 MHz Band 22.5Noise Figure 5 dB nominalPower Requirements 12 V 1.5 A / USB 5V 2.1 A______Specifications
DRIVE SLEEK CELL PHONE SIGNAL BOOSTER 13______(SPECIFICATIONS cont.)The term “IC” before the radio certification number only signifies that Industry Canada technicalspecifications were met. Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power o on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut o until the Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by weBoost could void the authority to operate this equipment.
3301 East Deseret Drive, St. George, UT 866.294.1660 www.weboost.com support.weboost.comCopyright © 2016 weBoost. All rights reserved.weBoost products covered by U.S. patent(s) and pending application(s)For patents go to: weboost.com/us/patentsNOT AFFILIATED WITH WILSON ANTENNA GDE000009_RevP_ErinFCC_07.10.172 YEAR WARRANTYweBoost Signal Boosters are warranted for two (2) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase.Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weoost. weBoost shall, at its option, either repair or replace the product.This warranty does not apply to any Signal Boosters determined by weBoost to have been subjected to misuse, abuse, neglect, or mishandling that alters or damages physical or electronic properties.Replacement products may include refurbished weBoost products that have been recertified to conform with product specifications.RMA numbers may be obtained by contacting Customer SupportDISCLAIMER: The information provided by weBoost is believed to be complete and accurate. However, no responsibility is assumed by weBoost for any business or personal losses arising from its use, or for any infringements of patents or other rights of third parties that may result from its use.

Navigation menu