Verizon Connect AT-100 Dongle connecting to the automotive OBD port. Dongle has GSM radio, GPS receiver, Bluetooth radio. Primary usage is automobile tracking. User Manual AT 100 UsManCom
Verizon Telematics Dongle connecting to the automotive OBD port. Dongle has GSM radio, GPS receiver, Bluetooth radio. Primary usage is automobile tracking. AT 100 UsManCom
Contents
- 1. AT-100_UsMan
- 2. AT-100_UsManC
- 3. AT-100_UsManCom
AT-100_UsManCom
![This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-tions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Modications not expressly approved by Hughes Telematics, Inc. could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.#1087_8_23](https://usermanual.wiki/Verizon-Connect/AT-100.AT-100-UsManCom/User-Guide-1532346-Page-1.png)
![The internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.Exposure to Radio Frequency (RF) Signals:The wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limit for exposure to radio frequency (RF) energy set by the OET Bulletin 65 Supplement C. These limits are part of comprehensive guidelines and established permitted levels of RF energy for the general population. These guidelines are based on the safety standards previously set by international standard bodies. These standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health.This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.This device has been shown to be capable of compliance for localized specic absorption rate (SAR) for uncontrolled environment / general public exposure limits specic in ANSI/IEEE C95.1-1992 and had been tested in accordance with the measurement procedures specied in IEEE Std. 1528-2003 Decem-ber 2003.© 2011 Hughes Telematics, Inc. In-Drive is a registered trademark of Hughes Telematics, Inc.](https://usermanual.wiki/Verizon-Connect/AT-100.AT-100-UsManCom/User-Guide-1532346-Page-2.png)