Venture Global HAX-900 Wireless Indoor Motion Detector User Manual 2

Venture Global Limited Wireless Indoor Motion Detector 2

Manual

PIR lensPowerSwitchLED indicatorMounting backet9V battery(6F22)Part & FunctionBattery InstallationThe PIR sensor works with the receiver (chime) and must be paired before usingStep 1: Insert battery and switch on the sensor.Step 2: Insert batteries to the receiver (chime).Step 3: Enter pairing mode for receiver (chime unit). Press and hold the zone selector button 3 seconds. The LED #1 will flash.Step 4: Press the button again to move to the zone you want to pair with. Press melody selector to scroll through the melodies. Once you hear your preferred melody, do not press again as it is now selected. Step 5: Once you have selected the zone and melody, trigger the PIR sensor once. To trigger the sensor move your hand across the lens. If successful, the receiver will generate a short tone. Press the button to exit pairing mode, the system is now ready to use.Test the SensorInsert the battery and switch on the PIR sensor, it will start to detect motion after 30 seconds. Walk to the front of the sensor within 8m.Timer setting5 seconds5 minutesUser Manual HAX-900PairingFCC Statement:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * Reorient or relocate the receiving antenna. * Increase the separation between the equipment and receiver. * Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Modifications to this product will void the user's authority to operate this equipment.Once the motion has been detected, the sensor will send out a trigger signal to the receiver (chime) then go into a sleep mode for 5 seconds or 5 minutes. During this time it will not detect motion.Switch off the sensor when not use.PIR sensor effectivearea8mo83Top View Side View8mo30o403m

Navigation menu