Venture Global HAX-600 Wireless Pull Station User Manual 3

Venture Global Limited Wireless Pull Station 3

Manual

CODE MATCHING AND MELODY SELECTIONPARTS & FUNCTIONBATTERY INSTALLATIONIDZone selectorbuttonMelody selectorCHI MELIG HTLIG HT & CHIM ERESETBack HolderMounting Holes ResetBattery CoverBattery CompartmentLEDPullHandle+++Remove the battery cover Replace thebattery coverInsert a 12V battery23AThe Pull Station works with the receiver (chime) and must be paired before usingStep 1: Insert battery to the sensor.Step 2: Insert batteries to the receiver (chime).Step 3: Enter pairing mode for receiver (chime unit). Press and hold the zone selector button 3 seconds. The LED #1 will flash.Step 4: Press the button again to move to the zone you want to pair with. Press melody selector to scroll through the melodies. Once you hear your preferred melody, do not press again as it is now selected. Step 5: Once you have selected the zone and melody, trigger the pull station by pulling the handle. If successful, the receiver will generate a short tone. Press the button to exit pairing mode, the system is now ready to use.INSTALLATIONTEST THE SENSORPull the handle to test the pull station after installation. The LED on the toilet pull will lit up 1.2 second to indicate it is transmitting.The unit will keep transmission every 1.3 seconds until release the handle.o/ 7mm25mmMark 4 holes onthe celling using a pencilRequires an electric drill for holes to fix the Sensor with the provided ram plug and screws.++++++++RESETRESETRESETMount the unit to the celling.TYPICAL LOCATIONAlongside the WCSet upper handle800-1000mm from floorSet lower handle100mm from floor100mm800mmCANCELLING THE ZONE INDICATORYou can press the 'reset' button on the pull station to deactivate the zone indicator on the receiver. You can also press the 'reset' button on the back of the receiver to deactivate the zone indicator. UserManualFCC Statement:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * Reorient or relocate the receiving antenna. * Increase the separation between the equipment and receiver. * Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Modifications to this product will void the user's authority to operate this equipment.

Navigation menu