Ubiquiti LS9 900 MHz wireless mini-PCI module User Manual LS2 info manual

Ubiquiti Networks, Inc. 900 MHz wireless mini-PCI module LS2 info manual

Manual

Hardware Information GuideLiteStation9900MHz Outdoor Wireless Bridge
INSTALLATION INSTRUCTIONS
Regulatory InformationFCC StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuantto Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinteference in a residential installation.The equipment generates, uses and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications. However, thereis no gurantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one of the following measures:• Reorient or relocate the receiving antenna• Increase the separation between the equipment and receiver• Consult the dealer or an experienced radio/TV technician for helpTo assure continued compliance, any changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate this equipment.FCC Radiation Exposure StatementThis equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolledenvironment. This equipment should be installed and operated with a minimum distance of 20 centimetersbetween the radiator and your body.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may causeundesired operation.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The antennas used for this transmitter must be installed to provide a separation distance of at least 20cmfrom all persons and must not be located or operating in conjunction with any other antenna or transmitter
CAUTION1.) To comply with FCC RF exposure compliance requirements, a separation distance of at least20cm must be maintained between the antenna of this device and all persons.2.) This transmitter must not be collocated or operating in conjunction with any other antenna ortransmitterLimited End User Product WarrantyPursuant to all provisions described herein, Ubiquiti Networks products are warranted for (1) year from thedate of purchase against defects in the build materials and workmanship. Ubiquiti or its reseller shall usecommercially reasonable efforts to promptly correct a nonconformity.The above warranty is voide if the alleged defect cannot be verified by Ubiquiti or if, as determined byUbiquiti, the product failure was due to tampering, abuse, misuse, accident, shipping, handling, or storage;or if the product has been installed, used, or maintained in a manner not described in the product usermanual, if the product has been altered in any way, or if product serialization has been altered. Anyattempt to disassemble or repair the product by anyone other than Ubiquiti immediately voids thiswarranty.This warranty applies only to the original End User purchaser of the product and may not be transferred toany other individual or entity.By using the product, the original End User purchaser agrees to and is bound by these terms and conditions.In the event that a product fails to meet this warranty and Ubiquiti’s authorized reseller is notified inwriting of such failure within the warranty period, Ubiquiti shall, at its own discretion, either repair theproduct or replace it with the same or a functionally-equivalent product free of charge. Replacementproducts may contain refurbished materials in whole or in part. Ubiquiti will honor this warranty providedthe product is returned through an authorized Ubiquiti reseller or dealer with shipping charges prepaid,along with a proof of purchase describing the original purchase date and product serial numbers ifapplicable. The authorized reseller must acquire a Return Materials Authorization (RMA) number fromUbiquiti prior to returning any product. Ubiquiti does not accept shipments of defective products withoutshipping charges prepaid.

Navigation menu