UTC Fire and Security Americas 869-FOB 319.5MHz AM 4-BUTTON DESIGNER FOB User Manual

UTC Fire & Security Americas Corporation, Inc. 319.5MHz AM 4-BUTTON DESIGNER FOB

Contents

User Manual

1,QVWDOODWLRQ,QVWUXFWLRQV*(6HFXULW\'PRELIMINARY 12/30/04 Product SummaryThe Flip Top KeyChain Touchpad enables the user to turn the system on and off after exiting or before entering the home or to turn on the siren and to call the central monitoring station if there is an emergency. If lamp modules have been installed, the KeyChain Touchpad can be used to turn all lights using the lamp modules on or off.Installation OverviewGeneral InformationThe KeyChain Touchpad is a lithium battery-powered, wireless touchpad designed to fit on a keychain, in a pocket or purse. It provides users a convenient option for the following system opera-tions:•Arm the system (doors, windows, and motion sensors)•Arm the system with no entry delay (if pro-grammed)•Disarm the system •Trigger Panic alarms•Turn system controlled lights on or off•Open the garage door or turn outside lights on (if programmed)Installation GuidelinesUse the following guidelines when adding Key-chain Touchpads to the system:•KeyChain Touchpads are learned into the Con-trol Panel as sensors or touchpads.•KeyChain Touchpads when programmed as sensors are programmed as a non-supervised sensor. •Each learned KeyChain Touchpad uses one of the available sensor numbers.•KeyChain Touchpads can be programmed with no entry delay.ProgrammingFollow these instructions to program the touch-pad:1. Open the control panel cover.2. Enter Utility Access Code 1 or 2 using the red-numbered buttons.3. Press Add from the Start Menu.4. Press the Sensor/Remote button from the Main menu and you will hear keychain remote.Note: When adding sensors, if you wish to use a more descriptive location you may press the option button to use the compass directions (north, north east, east, south east, south, south west, west, north west).5. Press DONE.6. Enter the sensor type number (01, 03, 06, or 07) with the red numbered keys.Note: If you wish to use a sensor number other than the next available, enter a 2 digit sensor number with the red numbered keys immediately after entering the sensor type. 7. Press the lock and unlock buttons simulta-neously until the transmitter LED is lit.Testing Flip Top KeyChain Touchpads Used with the SIMON® Control PanelPerform Sensor TestThe following steps describe the guidelines for testing sensors. 1. Open the Control Panel cover. 2. Enter the Utility Access Code 1 or 2 using the red-numbered buttons.3. Press the Test button once.4. Press DONE.5. Trip the sensor by pressing the Lock and Unlock buttons simultaneously until the LED is lit.0+]$0%XWWRQ'HVLJQHU)REDocument No. 466-2207 Rev. ADecember 2004
26. Note the number of siren beeps indicating how many RF packets the Control Panel received from the sensor. You should hear 7-8 beeps. SpecificationsModel No.: 600-1003-95RRF Frequency: 319.5 MHzCompatibility: Simon and Concord™ control panelsBattery Type: 3 V lithium batteryEstimated Battery Life: 5 to 8 yearsDimensions (mm): 58 x 37 x 12 (L x W x H)FCC NOTICEThis device complies with FCC Rules Part 15. operation is subject to the following two conditions:1) This may not cause harmful interference.2) This device must accept any interference that may be received, including interference that may cause undesired operation.Changes or modifications not expressly approved by Inter-active Technologies, Inc. can void the user’s authority to operate the equipment.FCC ID: B4Z-869-FOB)*(6HFXULW\

Navigation menu