TianJin HuaLai Technology WHSB1 WYZE Sensor Bridge User Manual

TianJin HuaLai Technology Co.,Ltd. WYZE Sensor Bridge

User manual

Wyze Sense Starter KitQUICK START GUIDESETUP1Insert the Sensor Bridge into the USB port of a Wyze Cam or Wyze Cam Pan.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful IN THE BOXWyze Contact Sensor(battery pre-installed)Wyze Motion Sensor(battery pre-installed)Wyze Sensor BridgeQuick Start GuidePinx2x1x1x1x1STATUS LIGHTCONTACT SENSOR PLACEMENT MOTION SENSOR PLACEMENTFCC Compliance StatementBridgeSensorsSolid yellow lightThe device is powered on, but not connectedFlashing yellow/blue lightThe bridge is connectingSolid blue lightThe device is working properlyFlashing blue lightThe device is ready to pair witha sensor Ensure the two sections of the Contact Sensor are at most 2 cm apart when closed.Place Sensor approximately 6 feet high and ensure the Wyze Logo is in the top left corner.Red lightSensor triggeredPOWERWyze Sensor Bridge2Log into your Wyze account and add a new device from the Home page. Follow the instructions in the Wyze app to finish setup.3Repeat Step 2 for each Contact and Motion Sensor.Wyze@WyzeCam40mm40mm2cm(max.)interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.Wyze Sensor BridgeWyze Motion SensorWyze Contact Sensor( WHCS1) ( WHMS1) ( WHSB1)NEED HELP?Resources & Supportwww.wyze.com/supportCommunity www.wyze.com/forumsChanges or modifications not expresslyapproved by the party responsible forcompliance could void the user's authorityto operate the equipment.

Navigation menu