TECHCity Technology RC-09 Remote Controller User Manual RC 09

TECHCity Technology Co., Ltd. Remote Controller RC 09

Users Manual

RC-09 User Manual Mode Name : RC-09 Battery : AAA*2 Frequency : 433.92MHz Device KeysSetting KeysActive KeysFCC Caution : To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
ID Setting 1. Take one battery out from remote controller, press any key then reload battery. 2. The red LED indicator at front panel lights up for 5 seconds. 3. Within 5 seconds, enter a set of 4 numbers to finishes digital ID setup Note: There are 10000 combination of digital ID code range from 0000 to 9999. User may change it when desire. Please note that the digital ID code must correspond to the chosen light, wall and power switch’s ID enable for controller to control them. ID check 1. Press and hold key. 2. Press and count the number of times red LED indicator blinks, which represent the first digit of the code. Repeat step with ,and to check for other digits. Note: The factory default code of the remote controller is “0000”. User need to change the code correspond to light switch’s digital ID or power plug ID to enable the RC-06 Smart Remote Controller to control them.
Lighting Control Note: Please make sure the chosen light, wall or power switch’s digital ID code is consistent with RC-09’s digital ID code. 1. Select the control Zone of or 2. Press device key from to then release, red LED indicator will light up and within 5 seconds, press or to send command, red LED indicator will blink once. 3. If user changed mind after select a set of device but want to control another set of device, within 5 seconds of pressing the first set of device key, press second device key from to and release, backlight will blink twice to indicate the change of control, then press or to activate the command. Home Appliances Control 1. Select one of the home appliances device 2. Press active key then release to control the home appliance.
+- or Setting Keys Learn+Devices Key : going to device Learning Mode Set+No.1 or 2 or 3 or 4: check the RC-09’s ID Learn+MACRO : going to MACRO edit mode Set+Off : clear the memory MACRO+No. 0~9 : MACRO Active

Navigation menu