Symbol Technologies DM4046 VoIP Phone using 802.11b User Manual 72 51346 01RevB p65

Symbol Technologies Inc VoIP Phone using 802.11b 72 51346 01RevB p65

Contents

Addendum

Hearing Aid CompatibilityThis product is marked HAC showing compliance with theapplicable requirements of FCC Part 68 and CS03-Part 5.Radio Frequency InterferenceRequirements for Home or Office UseThis device has been tested and found to comply with the limitsfor a Class B digital device pursuant to Part 15 of the FederalCommunications Commissions (FCC) Rules and Regulation.These limits are designed to provide reasonable protectionagainst harmful interference when the equipment is operated ina residential environment. This equipment generates, uses andcan radiate radio frequency energy and, if not installed andused in accordance with the instruction manual, may causeharmful interference to radio communications.However, there is no guarantee that interference will not occurin a particular installation. If the equipment does cause harmfulinterference to radio or television reception, which can bedetermined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more ofthe following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipmentand receiver.• Connect the equipment into an outlet on a circuit differentfrom that which the receiver is connected.Radio Frequency InterferenceRequirements-CanadaThis Class B digital apparatus meets the requirements of theCanadian Interference-Causing Equipment Regulations.Cet appareil numérique de la Classe B respecte toutes lesexigences du Reglement sur le Materiél Brouilleur du Canada.FCC RF Exposure GuidelinesTo comply with RF safety requirements use the specificbelt clip. All other belt clips should be avoided andmay not comply with RF safety requirements. TheFCC has granted an Equipment Authorization forNetVision phones with all reported Specific Absorption Rate(SAR) levels evaluated as in compliance with the FCC RFemission guidelines. SAR information on NetVision phones is onfile with the FCC and can be found under the Display Grantsection of http://www.fcc.gove/oet/fccid.European Economic AreaThe European variant is intended for use throughout theEuropean Economic area, however authorization for userestricted as follows:• European standards dictate maximum radiated transmitpower of 100 mW, EIRP and frequency range 2.400 -2.4835 GHz• France, the equipment is to be restricted to the 2.4465 -2.4835 GHz frequency range• Belgium outside, the equipment is to be restricted to the2.460 - 2.4835 GHz frequency range• Operation in Italy requires a user license.Hereby, Symbol Technologies, Inc., declares that thisproduct is in compliance with the essential requirementsand other relevant provisions of Directive 1999/5/EC.A Declaration of Conformity may be obtained fromhttp://www2.symbol.com/doc/.Laser Devices(Only applies to Data Phone-4046)Symbol products using lasers comply with US 21 CFR1040.10,Subchapter J and IEC825/EN 60 825 (or IEC825-1/EN60-825-1, depending on the date of manufacture). The laserclassification is marked on one of the labels on the product.Class 1 Laser devices are not considered to be hazardous whenused for their intended purpose. The following statement isrequired to comply with US and international regulations:Use of controls, adjustments or performanceof procedures other than those specified hereinmay result in hazardous visible or invisible laserlight exposure.Class 2 laser scanners use a low power, visible light diode.As with any very bright light source, such as the sun, the usershould avoid staring directly into the light beam. Momentaryexposure to a Class 2 laser is not known to be harmful.Samples of Laser Warning LabelsCAUTION: LASER LIGHT WHEN OPEN. DO NOT STARE INTO BEAM.ATTENTION - LUMIERE LASER EN CAS D'OUVERTURE NE PAS REGARDER DANS LE FAISCEAU.VORSICHT - LASERLICHT, WENN ABDECKUNG GOFFNET. NICHT IN DEN STRAHL BLICKEN.LASER LIGHT - DO NOT STARE INTO BEAMCLASS 2 LASER PRODUCTLASERLICHT-NICHT IN DEN STRAHL BLICKENLASER KLASSE 2LUMIERE LASER - NE PAS REGARDER DANS LE FAISCEAUAPPARIEL A LASER CLASS 2630 - 680 nm. 1mwLASER LIGHT DO NOT STARE INTO BEAM630 - 680nm LASER 1.0mW MAX OUTPUTCLASS II LASER PRODUCT
Customer SupportSymbol Technologies provides its customers with prompt andaccurate customer support. Use the Symbol Support Center asthe primary contact for any technical problem, question orsupport issue involving Symbol products. If the SymbolCustomer Support specialists cannot solve a problem, accessto all technical disciplines within Symbol becomes availablefor further assistance and support. Symbol Customer Supportresponds to calls by email, telephone or fax within the timelimits set forth in individual contractual agreements. Whencontacting Symbol Customer Support, please provide thefollowing information:• serial number (MAC address) of unit• part number or product name.North American ContactsInside North America, contact Symbol at:Symbol Technologies, Inc.One Symbol PlazaHoltsville, New York 11742-1300Telephone: 1-631-738-2400 / 1-800-SCAN 234Fax: 1-631-738-5990Symbol Support Center:Telephone: 1-800-653-5350Fax: (631) 563-5410Email: support@symbol.comInternational ContactsOutside North America, contact Symbol at:Symbol Technologies Technical Support12 Oaklands ParkBerkshire, RG41 2FD, United KingdomTel: 011-44-118-945-7000 or 1-631-738-2400 ext. 6213Product Information and DocumentationDocumentation for NetVision Products is available online athttp://www.symbol.com/services/downloads/nvdoclist.html.NetVision Phone®Regulatory SpecificationsRegulatory ComplianceSymbol RF products are designed to be compliant with the rulesand regulations in the locations into which they are sold andwill be labeled as required. The majority of Symbol RF devicesare type approved and do not require the user to obtain licenseor authorization before using the equipment. Any changes ormodifications to Symbol Technologies equipment not expresslyapproved by Symbol Technologies could void the user’sauthority to operate the equipment.Applying the RegulatoryCountry StampA regulatory label is applied in the battery compartment ofthe NetVision Phone. The regulatory label signifies that theNetVision Phone is approved for use in the following countries:• United States• Canada• Australia• Japan (approval pending)• Mexico (approval pending)• EuropeAustria, Belgium, Croatia, Denmark, Estonia, Finland,France, Germany, Greece, Iceland, Ireland, Italy,Liechtenstein, Luxembourg, Netherlands, Norway, Portugal,Spain, Sweden, Switzerland, United Kingdom.For approved countries other than those listed above, a sheet ofadhesive country stamps may be enclosed within the NetVisionPhone package.To Apply the Country Stamp:1. Peel the stamp appropriate to the country where theNetVision Phone is used.2. Apply the country stamp in the space provided on theregulatory label located in the battery compartment.Operation of the device without a regulatory label orthe correct country stamp is illegal.CopyrightCopyright © 2001 by Symbol Technologies, Inc. All rights reserved.No part of this publication may be modified or adapted in any way, for anypurposes without permission in writing from Symbol Technologies, Inc. (Symbol).The material in this documentis subject to change without notice. Symbol reservesthe right to make changes to any product to improve reliability, function, ordesign. No license is granted, either expressly or by implication, estoppel,or otherwise under any Symbol Technologies, Inc., intellectual property rights.An implied license only exists for equipment, circuits, and subsystems containedin Symbol products.Symbol, the Symbol logo and Spectrum24 are registered trademarksof Symbol Technologies, Inc. Other product names mentioned in this manual maybe trademarks or registered trademark of their respective companies and arehereby acknowledged. IBM is a registered trademark of International BusinessMachine Corporation. Microsoft, Windows, and Windows NT are registeredtrademarks of Microsoft Corporation.PatentsThis product is covered by one or more of the following U.S. and foreign Patents:U.S. Patent No.4,496,831; 4,593,186; 4,603,262; 4,607,156; 4,652,750; 4,673,805;4,736,095; 4,758,717; 4,760,248; 4,806,742; 4,816,660; 4,845,350;4,896,026; 4,897,532; 4,923,281; 4,933,538; 4,992,717; 5,015,833;5,017,765; 5,021,641; 5,029,183; 5,047,617; 5,103,461; 5,113,445;5,130,520; 5,140,144; 5,142,550; 5,149,950; 5,157,687; 5,168,148;5,168,149; 5,180,904; 5,216,232; 5,229,591; 5,230,088; 5,235,167;5,243,655; 5,247,162; 5,250,791; 5,250,792; 5,260,553; 5,262,627;5,262,628; 5,266,787; 5,278,398; 5,280,162; 5,280,163; 5,280,164;5,280,498; 5,304,786; 5,304,788; 5,306,900; 5,321,246; 5,324,924;5,337,361; 5,367,151; 5,373,148; 5,378,882; 5,396,053; 5,396,055;5,399,846; 5,408,081; 5,410,139; 5,410,140; 5,412,198; 5,418,812;5,420,411; 5,436,440; 5,444,231; 5,449,891; 5,449,893; 5,468,949;5,471,042; 5,478,998; 5,479,000; 5,479,002; 5,479,441; 5,504,322;5,519,577; 5,528,621; 5,532,469; 5,543,610; 5,545,889; 5,552,592;5,557,093; 5,578,810; 5,581,070; 5,589,679; 5,589,680; 5,608,202;5,612,531; 5,619,028; 5,627,359; 5,637,852; 5,664,229; 5,668,803;5,675,139; 5,693,929; 5,698,835; 5,705,800; 5,714,746; 5,723,851;5,734,152; 5,734,153; 5,742,043; 5,745,794; 5,754,587; 5,762,516;5,763,863; 5,767,500; 5,789,728; 5,789,731; 5,808,287; 5,811,785;5,811,787; 5,815,811; 5,821,519; 5,821,520; 5,823,812; 5,828,050;5,848,064; 5,850,078; 5,861,615; 5,874,720; 5,875,415; 5,900,617;5,902,989; 5,907,146; 5,912,450; 5,914,478; 5,917,173; 5,920,059;5,923,025; 5,929,420; 5,945,658; 5,945,659; 5,946,194; 5,959,285;6,002,918; 6,021,947; 6,031,830; 6,036,098; 6,047,892; 6,050,491;6,053,413; 6,056,200; 6,065,678; 6,067,297; 6,068,190; 6,082,621;6,084,528; 6,088,482; 6,092,725; 6,101,483; 6,102,293; 6,104,620;6,114,712; 6,115,678; 6,119,944; 6,123,265; 6,131,814; 6,138,180;6,142,379; 6,172,478; 6,176,428; 6,178,426; 6,186,400; 6,188,681;6,209,788; 6,216,951; 6,220,514; 6,243,447; 6,244,513; 6,247,647;6,308,061; 6,250,551; 6,295,031; D305,885; D341,584; D344,501;D359,483; D362,453; D363,700; D363,918; D370,478; D383,124;D391,250; D405,077; D406,581; D414,171; D414,172; D418,500;D419,548; D423,468; D424,035; D430,158; D430,159; D431,562;D436,104.Invention No. 55,358; 62,539; 69,060; 69,187 (Taiwan); No. 1,601,796;1,907,875; 1,955,269 (Japan); European Patent 367,299; 414,281; 367,300;367,298; UK 2,072,832; France 81/03938; Italy 1,138,713Symbol Technologies, Inc.One Symbol PlazaHoltsville, NY11742-1300*72-51346-01*72-51346-01Revision B

Navigation menu