Spectralink RCC400 Standard Base Station User Manual Regulatory Guide

Spectralink Corporation Standard Base Station Regulatory Guide

Contents

Regulatory Guide

REGULATORY INFORMATIONLink 6020 Wireless Telephone Link WTS Base StationsP/N: 72-1401-00-ALink 6020 Wireless TelephonesCanada (Safety) 1 CAN/CSA-C22-2 No. 60950-1Canada Industry Canada RSS-210 IC: 2128B-602XUnited StatesUL 60950-1United StatesPart 15, IYG602X21 TUV Rheinland of North America is a Nationally Recognized Testing Laboratory (NRTL) in the United States and is accredited by the Standards Council of Canada to test and certify products to Canadian National Standards. Clients can demonstrate compliance for both U.S. and Canadian markets through a single mark (cTUVus) on their product(s) which denotes compliance to U.S. and Canadian National Standards.Model Registered UnderLink 6020 602XLink Base Station RCC400RCC410RCO400RCO410RCH400RHO400International Certications Regulatory Model NumberTrademark InformationInformation in this document is subject to change without notice and does not represent a commitment on the part of SpectraLink Corporation. SpectraLink® LinkAre trademarks and registered trademarks of SpectraLink Corporation.The SpectraLink logo is a registered trademark in the United States of America and in other countries.SpectraLink Corporation 5755 Central Avenue Boulder, CO 80301 303 440 5330 800 676 5465 www.spectralink.comNotes and WarningsHAC—This equipment is Hearing Aid Compatible (HAC).Handset Operation Normal Position—Hold the handset as you would any other tele-phone, with the earpiece to your ear and speak into the microphone. The internal antenna is then positioned properly.Handset Operation Body-Worn Position—To maintain compliance with RF energy exposure guidelines, if you wear a handset on your body when transmitting, always use the handset with a SpectraLink-supplied accessory as described in the user guide for this handset. SpectraLink supplies belt clips, holsters and lanyards for body-worn operation. Use of accessories not supplied by SpectraLink may cause the handset emissions to exceed RF energy exposure guidelines.The user should not make changes or modications not expressly approved by Spec-traLink. Any such changes could void the user’s authority to operate the equipment.Warning—The earpiece/mouthpiece region on the handset can attract and retain small objects.•••••
Wireless Telephones Link 6020: FCCID IYG602XThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Base StationsThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.! SpectraLink recommends the use of shielded cable for all external signal connections in order to maintain FCC Part 15 emissions requirements.The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF emissions guidelines.SAR information on this model phone is on le with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID IYG602X.Additional information on SAR can be found on the Cellular Telecommunications Industry Association (CTIA) web-site at:http://www.ctia.org.The only authorized headsets that may be utilized with the the Link 6020 Wireless Tele-phone are those obtainable from SpectraLink or its reseller partners.The peak SAR values of the Link 6020 Wireless Telephone are:Body (0.223 mW/g)Head (0.463 mW/g)SAR: Frequency range 902.4817 – 927.4826 MHzYour Wireless Telephone is a low-power radio transmitter and receiver. When it is ON, it receives and also sends out radio frequency (RF) signals. In August 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless telephones. Those guidelines are consistent with the safety standards previously set by both U.S. and international standards bodies:ANSI C95.1 (1992) American National Standards InstituteNCRP—Report 86 (1986) National Council on Radiation Protection and Measure-mentsICNIRP (1996) International Commission on Non-Ionizing Radiation Protection;DHWC—Safety Code 6 Department of Health and Welfare CanadaThose standards were developed by independent scientic organizations through periodic and thorough evaluation of scientic studies. The standards include a substantial safety mar-gin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specic Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.2 Tests for SAR are conducted using standard operating positions specied by the FCC with the telephone trans-mitting at its highest certied power level in all tested frequency bands. Although the SAR is determined at the highest certied power level, the actual SAR level of the telephone while operating can be well below the maximum value. This is because the telephone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless Base Station antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested and certied to the FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. While there may be differences between the SAR levels of various telephones and at various positions, they all meet the government requirement for safe exposure. 2 In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any variations in measure-ments.••••FCC InformationWireless Telephones Link 602XThis device complies with RSS-210 of Industry Canada. Operation is subject to the follow-ing two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device.This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful inter-ference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interfer-ence at his own expense. This Class A digital apparatus complies with Canadian ICES-003.Certication Number IC: 2128B-602XBase StationsRCC400 RCC410 RCO400 RCO410 RCH400 RHO400This device complies with RSS-210 of Industry Canada. Operation is subject to the follow-ing two conditions: 1) This device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device.This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful inter-ference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interfer-ence at his own expense. This Class A digital apparatus complies with Canadian ICES-003.Certication Number IC: 2128 101 416AIndustry Canada (IC) Notice Specic Absorption Rate (SAR) Information

Navigation menu