Solatube SLT Touch screw remote control Purpose of User Manual 1

Solatube International Inc. Touch screw remote control Purpose of 1

User Manual

Thanks for choosing the wireless lamp products. In order to be better to use the product, please read this operation instruction seriously.The Touch screw remote control adopts the latest RF technology and digital identification technology, which makes the products stable and high performance, as well make the system very easy to know which one is in need of service.Technical dataWorking frequency: 433.92MHzWorking voltage: DC6V (CR2032 x 2)Standby current: <30uAWorking current: ≤ 10mAEncoding mode: learning codeWorking temperature: -10~+50°CProduct size: 86 × 86 × 10mmUser manual of SLT-SYT100-1M Touch screw remote controlDiagramFigure 1InstallationUsage methodFigure 2Double sidedtape①Pull out the insulationplastic at first use. ②　Stick the calling button on the wall by double sided tap.Change batteryNote: the pairing method, please refer to the user manul of lamp.Figure 33V3V(1) Put the screwdriver into the disassemble port and push it up.(2) Take out the upper part of the caller from the bottom(3) Change the battery.Press the button, the light on, press again, the light off. Touch buttonTransmit / low powerindicatorBattery boxGlassWall
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.&DXWLRQ$Q\FKDQJHVRUPRGLILFDWLRQVQRWH[SUHVVO\DSSURYHGE\WKHSDUW\UHVSRQVLEOH IRUFRPSOLDQFHFRXOGYRLGWKHXVHUVDXWKRULW\WRRSHUDWHWKHHTXLSPHQW

Navigation menu