Shure orporated UR1MD Wireless Microphone Transmitter User Manual

Shure Incorporated Wireless Microphone Transmitter

User Manual

UR1M Micro Bodypack TransmitterAddendum27A12268 (Rev. 1) Printed in U.S.A.©2008 Shure IncorporatedSpecications:The following specications apply to the UR1M micro bodypack only.Features:Same audio performance as UR1• Rapid two-way infrared (IR) data transmission• User-adjustable RF output level (10 mW or 50 mW)• Operates with three types of primary batteries: alkaline, lithium or • NiMHAudio signal is input through a TA4F connector (UR1M) or a LEMO • connector (UR1MLEMO3)Selectable battery metering by battery type• Audio metering on UR1M transmitter• Frequency RangeBand RangeG1 470-530 MHzH4, H4E 518-578 MHzJ5 578-608, 614-638 MHzJ5E 578-638 MHzL3, L3E 638-698 MHzQ5 740-814 MHzQ6 740-752 MHzQ9 740-806 MHzQ10A 740-787 MHzR9 790-865 MHzR16, R18 794-806 MHzA24 779-788, 797-806 MHzJBX 806-810 MHzX1 944-952 MHzRF Carrier Frequency Range470-865, 944-952 MHz depending on regionWorking Range150 m (500 ft.), under typical conditions 500 m (1600 ft.) line-of-sight, outdoors for a single systemNOTE: Actual working range depends on RF signal absorption, reec-tion and interferenceRF Power OutputSelectable 10 mW or 50 mW depending on regionPower Requirements:Two 1.5V AAA alkaline, lithium primary, and NiMH batteriesCurrent Drain: 130 mA max. at 3V (normal RF power setting)200 mA max. at 3V (high RF power setting)Gain Adjustment Range –20 to +35 dBBattery Life (Typical): Alkaline: 6 hours (normal RF power) 4 hours (high RF power) Lithium primary: 9 hours (normal RF power)7 hours (high RF power)NiMH 1000 mAH: 6 hours (normal RF power)4 hours (high RF power)Select Battery Type:Set the micro bodypack transmitter switch to onPress enterkey, then scroll using button to select battery type. Press enterkey to conrm.Note: For the most accurate battery metering and performance, make sure to select the correct battery type.To open the micro bodypack transmitter, see illustrations below:Slide arrow downTransmitter LCD Interface and Controls:For additional information on the LCD Interface and controls, see UHF-R User Guide.UR1M
2Overall Dimensions49 mm L x 60 mm W x 17 mm D (1.9 x 2.38 x 0.66 in.) Net Weight62 g (2.2 oz.) without batteries WiringTA4F ConnectorMicrophone Element TA4F ConnectorTA4M ConnectorUR1M MIC JACK BOARDNOTE: LAVALIER MIC TIES PINS 3 AND 4 TOGETHER—GUITAR CABLE DOES NOT.Active LoadAudioGroundLEMO ConnectorConnectorConnectorUR1M LEMO BOARDAudioGroundMicrophone ElementUR1M Transmitter RF Output:Connector: SMAActual Impedance: 50 ΩPin Assignments: Shell = GroundCenter = SignalUR1M Transmitter Audio Input:Connector: 4-Pin male mini connector (TA4M) 3-Pin female mini connector (LEMO XRB.00.303) Input Conguration: Unbalanced, activeMaximum Input Level:(1 kHz, 1% THD)+5 dBu (sensitivity 0 dB) +15 dBu (sensitivity –10 dB)TA4M Connector Pin Assignments:Pin 1: GroundPin 2: +5 VDC biasPin 3: Audio, 200 kΩPin 4: Tied through active load (on main board) to ground.(On instrument adapter cable, Pin 4 oats)LEMO Connector Pin Assignments:Pin 1: Ground Pin 2: +5 VDC biasPin 3: Audio (8.2 kΩ between pin 2 and 3, internal to UR1M)REPLACEMENT PARTS AND ACCESSORIESFurnished AccessoriesAntenna, 470-530 MHz.....................................................................UA700Antenna, 518-578 MHz.....................................................................UA710Antenna, 578-698 MHz ....................................................................UA720Antenna, 740-865 MHz ....................................................................UA730Antenna, 944-952 MHz ....................................................................UA740Optional AccessoriesBodypack Pouch (Black) ............................................................. WA581BBodypack Pouch (White) ............................................................. WA581W3-Pin mini Lemo conversion kit........................................................WA3353-Pin mini Lemo plug for Lavalier ....................................................WA336Assembly Tool for WA336................................................................WA337NoteTo fully interact with the Receiver, it is recommended to upgrade the UR4 rmware to 1.50 or higher and Shure Wireless Workbench to 5.0Certication:UR1M: Type Accepted under FCC Parts 74 (FCC ID: DD4UR1MA, DD4UR1MB, DD4UR1MC, DD4UR1MD, DD4UR1MF, DD4UR1MG). Certied by IC in Canada under RSS-123 and RSS-102 (IC: 616A-UR1MA, 616A-UR1MB, 616A-UR1MC-616A, 616A-UR1MD). Meets the essential requirements of the European R&TTE Directive 99/5/EC (ETSI EN 300-422 Parts 1 & 2, EN 301 489 Parts 1 & 9) and is eligible to carry the CE marking.The “EU Declaration of Conformity” can be obtained from Shure Inc. or any of its European representatives. For contact information please visit www.shure.comLICENSING INFORMATION:Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements.Changes or modications not expressly approved by Shure Incorporated could void your authority to operate the equipment. Licensing of Shure wireless micro-phone equipment is the user’s responsibility, and licensability depends on the user’s classication and application, and on the selected frequency. Shure strongly urges the user to contact the appropriate telecommunications authority concerning proper licensing, and before choosing and ordering frequencies.Information to User:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealerThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Note: EMC conformance testing is based on the use of supplied and recommended cable types. The use of other cable types may degrade EMC performance.SHURE Incorporated http://www.shure.comUnited States, Canada, Latin America, Caribbean:5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int’l Fax: 847-600-6446Europe, Middle East, Africa:Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414Asia, Pacific:Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055

Navigation menu