Shin Chuan Computer SC600PDT-BW Portable Data Terminal User Manual SC600 revised by Joy

Shin Chuan Computer Co., Ltd. Portable Data Terminal SC600 revised by Joy

Manual Pt2

3-1 Chapter 3. Setting 3.1 Introduction To view available options for PDT’s setting, tap Start > Settings. Then, there are three items inside Settings: “Control Panel”, “Network and Dial-up” and “Taskbar and Start”. 3.2 Control Panel To view the Control Panel and settings you can modify by tapping Start > Settings > Control Panel. Figure 3-1 Control Panel
3-2 3.2.1 BarCode Setting CAUTION：Please do not enter into any Barcode Application Program before settings completing this Barcode. There are three Tabs for scanner configuration setting: “Basic” Tab, “Code Configure” Tab and “Code ID” Tab. In addition, there is “BarCode Setup” for the “Code Configure” Tab. 3.2.1.1 “Basic” Tab Figure 3-2 Basic Tab Table 3-1 Basic Explaining Field Name Function Explaining Select the numbers of beep tone after scan OK. None After scanning the barcode, do not give out beep sound. Beep After Scan OK One Time After scanning the barcode, give out beep one time.
3-3 Field Name Function Explaining Two Times After scanning the barcode, give out beep two times. Scan Timeout (sec) Select the scanning timeout duration (in seconds) from this pull-down list. <2 ~ 10 sec, Default: 5> None After showing barcode, do not action. CRLF After showing the barcode, jump to next row. Space After showing the barcode, jump one unit. Termination Code Tab After showing the barcode, jump a section. Disable Disable this functionality. Continuous Scan 1 ~5 sec Alternate second number of Continuous Scan. Select a method based upon the barcode scanning application you will use. Type Writing A unit continues a unit, fast showing barcode number. Keybd Message Copy & Paste Once show barcode number Prefix Type the desired label prefix in this text box Suffix Type the desired label suffix in this text box Default Press “Default” button to reset all configuration setting of “Basic” Tab into default values. F/W ver. Decoder firmware version. Set All To Default Press “Set All To Default” button to reset all configuration setting of “Basic” Tab, “Code Configure” Tab, “Code ID” Tab and all barcode of “BarCode Setup” into default values.

Navigation menu