Sercomm NA301ZW Smart home gateway with 802.11b/g/n and Z-Wave User Manual NA301 QIG zwave V1 1

Sercomm Corporation Smart home gateway with 802.11b/g/n and Z-Wave NA301 QIG zwave V1 1

Contents

User manual

i NA301 Compact Z-Wave Gateway User Guide
ii Table of Contents CHAPTER 1 INTRODUCTION ............................................................................................. 1Package Contents .............................................................................................................. 1Features .............................................................................................................................. 1LEDs ................................................................................................................................... 2CHAPTER 2 INITIAL INSTALLATION .............................................................................. 4Requirements ..................................................................................................................... 4Procedure ........................................................................................................................... 4CHAPTER 3 CONFIGURATION .......................................................................................... 5Configuration Program .................................................................................................... 5Home Screen ...................................................................................................................... 6Regulatory Approvals ....................................................................................................... 7 Copyright  2014. All Rights Reserved. Document Version: 1.0 All trademarks and trade names are the properties of their respective owners.
1 Chapter 1 Introduction This Chapter provides an overview of the Compact Z-Wave Gateway's fea-tures and capabilities. Congratulations on the purchase of your new Compact Z-Wave Gateway. The Compact Z-Wave Gateway is a consumer electronic device, which is used for home monitoring and security. Package Contents The following items should be included:  The Compact Z-Wave Gateway Unit  Power Adapter If any of the above items are damaged or missing, please contact your dealer immediately. Features  MT7620A processor with128MB Flash and 128MB SDRAM  One Ethernet port with RJ45 connector  Front Panel LEDs  Z-Wave Transceiver  USB 2.0 port  WPS button  Reset button  Sync button  Power In connector  Internal antenna for WiFi and Z-Wave 1
2 LEDs Top-mounted LEDs The Compact Z-Wave Gateway has five LEDs. Service  On (Green) - Control Point has made a successful activation to the Portal Server.  Off - Cloud service is not available.  Flashing - Attempting to establish a connection to the Portal Server. Z-Wave  On (Green) - Z-Wave function enabled.  Off - Z-Wave function disabled.  Flashing - Learn/exclusion mode is on. WiFi  On - Wireless connection available  Off - No Wireless connection available.  Flashing - Data is being transmitted or received via the Wireless connection. WAN  On (Green) - Ethernet connection established.  Off - No active connection on the corresponding Ethernet port.  Flashing - Data is being transmitted or received via the Ethernet (hub) port. POWER  On (Green) - Power On  Off - Power Off  Flashing - Reboot or Firmware upgrade.
3 Rear/Side Panel Power Port Connect the supplied power adapter here. ETHERNET Port Use standard LAN cable (RJ45 connector) to connect your PC to the port. USB Port The connector is USB host with support for mass storage device. Sync Button Push this button to synchronize for portal server or Z-Wave clients. WPS Button Push the WPS button on the device and on your other wireless device to perform WPS function that easily creates an encryption-secured wireless connection automatically. Reset This button has two (2) functions:  Reboot. When pressed and released, the Compact Z-Wave Gate-way will reboot (restart).  Clear All Data. This button can also be used to clear ALL data and restore ALL settings to the factory default values. To Clear All Data and restore the factory default values: 1. Power On. 2. Keep holding the Reset Button down for 8 seconds. Release the Reset Button. The Compact Z-Wave Gateway is now using the factory default values.
4 Chapter 2 Initial Installation This Chapter covers the software installation of the Compact Z-Wave Gateway. Requirements  Use a standard 10/100BaseT network (UTP) cable with RJ45 connector. Procedure 1. Choose an Installation Site Select a suitable place to install the Compact Z-Wave Gateway. 2. Connect LAN Cable Use standard LAN cable to connect devices to the Ethernet port on the Compact Z-Wave Gateway. 4. Power Up Connect the supplied power adapter to the Compact Z-Wave Gateway. Use only the power adapter provided. Using a different one may cause hardware damage. 5. Check the LEDs  The POWER LED should be ON.  The WAN LED should be ON (provided the PC is also ON.) 2
5 Chapter 3 Configuration This Chapter provides Setup details of the Z-Wave System. Configuration Program This Web Portal can help you to set up your Z-Wave system with the compatible devices. It allows you to securely access your home remotely from the Internet or a mobile phone. If you want to be notified when the events occur at home, the system will send you email and SMS notifications. Preparation Before attempting to configure the Compact Z-Wave Gateway, please ensure that:  Your PC can establish a physical connection to the Compact Z-Wave Gateway. The PC and the Compact Z-Wave Gateway must be directly connected (using the Hub port on the Compact Z-Wave Gateway) or on the same LAN segment.  The Compact Z-Wave Gateway must be installed and powered ON. Using your Web Browser To establish a connection from your PC to the Compact Z-Wave Gateway: 1. Start your WEB browser. 2. In the Address box, enter "HTTP://" and the IP Address of the Compact Z-Wave Gateway, as in this example, which uses the Compact Z-Wave Gateway's default IP Address: HTTP://192.168.0.1 3. When prompted for the User name and Password, enter values as follows:  User name admin  Password admin 3
6 Home Screen After log in, you will see the Home screen. When you connect in future, you will see this screen when you connect. An example screen is shown below.
7 Regulatory Approvals FCC Statement This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica-tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices).  Any changes or modifications not expressly approved by the party responsible for compli-ance could void the authority to operate equipment.  This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.  End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.  For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. CE Approvals The Compact Z-Wave Gateway and the Ethernet Compact Z-Wave Gateway meet the guidelines of the European Union and comply with the 99/5/EEC and RTTE 99/5EG directives, including the following standards:  EN 60950-1
8 This is a Class B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Navigation menu