Sensity Systems WPEA-252NI 802.11a/b/g/n Mini PCIe Module User Manual Sensity Video Node Install Guide UL submission v2

Sensity Systems 802.11a/b/g/n Mini PCIe Module Sensity Video Node Install Guide UL submission v2

Sensity_Video_Node_Install_Guide_UL_submission_v2

VIDEO NODE INSTALLATION / REFERENCE GUIDE Environmental Considerations  Operational Temperature: -30°C - +55°C (-22°F - 131°F)  Storage Temperature: -50°C - +65°C (-58°F - 149°F)  Ingress Protection Rating: IP65 Compliant Required Tool List  Flat Head Screwdriver  T20 Torx Driver  Cable De-Latching Tool  UV resistant outdoor cable ties Power, Current and Weight Requirements Voltage Configuration Power (Watts) Current (A) Maximum Weight (lbs.) 100-277V 18W 0.06 – 0.15 9.0 480V 20W 0.05 10.5 Pole Mounting Requirements Mounting Type Horizontal Pole Mount Vertical Pole Mount Round Pole Diameter 1 5/8” – 2 3/8” Minimum 3” Square Pole Dimension Minimum 4” height Minimum 3” width Assembly and Mounting Instructions Pole Mounting illustration is shown. Box arm mounting instructions are same, substituting pole for box arm following mounting requirement size above. 1. Install the Video Node Bracket onto the pole with the correct orientation according to illustration below. The power connector for the Video Node should point towards the luminaire. Install the bracket using supplied stainless steel bands. Tighten bands until secure and bracket will not move. Do not over-tighten. SAFETY PRECAUTIONS / INSTALLATION CONSIDERATIONS  Installation and service should be performed by a qualified licensed electrician.  All electrical work should be completed by a licensed electrical contractor.  Installation should conform to all national and/ or local municipal laws and codes.  Disconnect or safe-off all power before installation.  DO NOT INSTALL DAMAGED PRODUCT! This Video Node has been properly packed so that no parts should have been damaged during transit. Inspect to confirm. Any part damaged or broken during or after assembly should be replaced.  These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, please contact Sensity Systems directly.  Installation is intended for outdoor luminaires. Product should not be installed ≤20ft from ground level and must be considered out of reach from normal access.  Product must be grounded per supplied ground provision per national and/ or local municipal laws and codes. Unit must not be under normal operation if left ungrounded.

Navigation menu