Sensio America SA40699 LED Wireless Remote User Manual

Sensio America, LLC LED Wireless Remote

User manual

User manual Product name: LED Wireless Remote Model: SA40699 Manufacture: Signcomplex Limited Group1:on Group2:on powerr Group4:off Group3:off Group2:offn Group1:off Group3:on Group4:on
Operation : 1:Turn on the power to the cotrol box 2：there are four groups of witches for control different colours, the buttom for UP or, down can adjust the density of colour, Warning: 1. Good heat emission condition may extend service life of the controller. Please put the product under the environment with good ventilation. 2. Ensure that the voltage complies with the requirement of voltage scope of the product. 3. The line size used must bear the connected load and ensure that connection is firm. 4. before debugging with electricity, ensure that all wire connection is correct to avoid. damage to lamps due to wrong wire connection. 5. If the failure takes place, don’t repair it by yourself. Please contact the manufacturer.
FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between theequipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.

Navigation menu