SYMA MODEL AIRCRAFT GC88752-13 wifi Camera User Manual DVM

GUANGDONG SYMA MODEL AIRCRAFT INDUSTRIAL CO., LTD wifi Camera DVM

User Manual

1 User manual Wi-Fi 2.4G frequency range：2412-2462MHz for 11b/g/n(HT20) Senor Senor CMOS,1/5”color resolution ratio 640*480（300k pixel） focal length 3.6mm Lens focal diameter ratio F2.4 viewing angle 60。 minimum illumination 1.0Lux@550nm video Image coding format H.264 image resolution; VGA（640x480）/ QVGA（320x240）/QQVGA(160x120) Maximum transmission rate of image 25fps Light frequency 50Hz、60Hz、Indoor and outdoor adaptive V-REV Vertical and horizontal image flip AWB SUPPORTING Wireless network interface; IEEE802.11b/g/n antenna gain 2.0dB Working model AP networking protocol; networking protocol; TCP/IP，DHCP，SMPT，HTTP，DDNS，UPNP working temperature 0 - 50C°，20% - 80% storage temperature -10°C ~ 60°，0% - 90% working voltage 3.3V ~ 5V working current 200mA ~ 250mA OPERATION DISTANCE: 2-3M
2 Search and install APP “WIFI GO”, swich No of airplane, the green light will be flashing in 5 seconds, and search to the "FPV_WIFI__XXXX" in mobile phone set, so light keeping when WIFI is connected,
3 Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: □Reorient or relocate the receiving antenna. □Increase the separation between the equipment and receiver. □Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. □Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu