Recsol I and C REP2000 900 MHz Cordless Telephone User Manual users manual

Recsol I&C; Co., Ltd. 900 MHz Cordless Telephone users manual

users manual

1. FUNCTION & FEATURES7) Noise cancellation8) Any key9) MEMORY10) Volume controlThe music phone adapt a noise cancellation circuit to providebetter sound quality.When there is an incoming call, you can make conversation bypressing any key button*Can memory 0~9 short number*If you memory a new number then memorized number will be erased.*If the setting finished, then you can listen the beeper sound-The Music phone set an initial sound value, when we shipped.-Louder :-Basic sound : ¨éDailing from short number¨êTo store favorite channel at e-dio mode:(Ex: You want memory "1" address with 123-4567)123-4567¨çMemory for short number:from stand-by status¨èMemory for PABX or key-phone connected caseIf the Music phone connect with PABX or Key-phone, thenmost of case you must dial external local connection num- ber(Normally"9") before dial telephone number.When you memory the telephone number you must insert "PAUSE" between local connection number and telephone.Press the numberfor memoryPress short numberfrom on of1) Long range cordless phone with 900MHz 900MHz cordless phone provide a longer distance than 46/49 Mhz phone. When you visit your neighborhood, you can carry the Music phone and use this phone even though you are in your neighborhood.2) Miniature typeSmall size and light weight can gives you for easy hand-carry.During you call, if the battery capacity drops to a certain levelyou may listen a beeper sound and "LOW BAT" LED will turn ON at which you must charge the battery.The hand-set unit locate far from base-set unit, then alarm beep will ringing. You can not call in that area, The Music phone designed for disconnect, after alarm beep. You musit move near area from the base-set unit.When the hand-set is riniging while it is on the cradle of base-set unit, if you pick-up the hand-set unit, the unit will go toTALK mode automatically(Auto Talk) and if you put the hand-set unit on the base-set unit, after calling it will go to standbymode automatically. (Auto Stand-by)Before using the music phone, the unit selects the empty channel which has no interference out of 40 channels auto-matically. You can call without any interference.3) Low battery indication4) 40Channel auto scanning5) Auto talf/stand-by6) Auto alarm for escape from communicable distanceVOLRDVOLVOLVOLVOLVOLVOLVOLMEMORYPAUSEMEMORYMEMORYMEMORYorMEMORYMEMORY11 1 1~~99900TALK¡ã¡å*#*Can memory 16 digit telephone numberDial one of short number between
2. PACKAGES3. LOCATION OF CONTROLSPlease check the contents as soon as you buy the Music phone1) Base-Set UnitMEMORYPAUSERD VOLHand-set UnitBase-Set Unit AdapterCALLCHARGEIN USECALLCHARGEIN USE12345<FRONT>1.Antenna : This is for communication terminal between base-set & Hand-set unit.2.Charge LED : When the hand-set is ON the cradle of base-set unit for charge, the LED will light, when charge the battery3.IN USE LED : The LED will turn ON when you are in TALK mode.4.CALL : If you press this button, you may listen a beep sound from hand-set so you may use for paging also.5.CHARGE TERMINAL : The power is being supplied through these terminals.8.TONE/PULSE SWITCH:For select a telephone exchanger for tone/pulse9.AUDIO/232C JACK :To connect with the computer. 6.PHONE JACK (TEL):To connect to the telephone line7.ADAPTER JACK:To connect with the adapter(DC9V, 200mA)8 976<BACK>- E-dio mode volume control ¨ç To increase volume : ¨è To decrease volume :- To channel up in e-dio mode : - To channel down in e-dio mode : If you press any number key button in e-dio mode then e-dio phone will be service your favorite channel.FUNFUNe-dioe-dioFUNFUNFLASHFLASHFLASHFLASH¡ã ¡ã¡ã¡å ¡å¡å* **# ##10) Channel up/down10) Favorite channel selectionLocal cord Audio/232C code
2) Hand-set unitMEMORYPAUSERD VOL12345678151412111016 17 181391.ANTENNA:This is for communication terminal between base-set & hand-set unit 8.VOLUME UP/CHANNEL UP/TONE<PULSE SWITCH(*¡ã/P¡æT) -VOLUME UP(¡ã):To increase volume level -TONE/PULSE SWITCH(P¡æT):To adjust tone/pulse method connection. -CHANNEL UP(¡ã):To increase channel level. 9.CHARGE TERMINAL:For battery charging. 13.DIAL BUTTON:To dial key-pad. 14.VOLUNE DOWN(¡å):To reduce the volume level CHANNEL DOWN(¡å):To reduce the channel level 15.C-MIC:Same as a transmitter in the phone. Transfer voice signal to an electric signal 16.BELL:When there is an incoming call and paging from base-set unit, the hand-set will be ringing. 17.ON/OFF SWITCH 18.EAR-PHONE JACK( )12.LOW BAT LAMP:The LED indicates low battery when you listen a beeper & LED turn ON 11.FLASH:Can use when you want to make a call-transfer and get special service from telephone company.10.VOLUME CONTROL/MEMORY -VOLUME CONTROL:For adjust the volume level -MEMORY:To store 10 sets of a frequently using telephone number. 7.MUTE:During pressed this button, then your counter-partner can not listen your voice 4.REDIAL/PAUSE -REDIAL:Redial for the last number, which you dialed. -PAUSE:To stop the dialing in a few seconds, it is convenient for PABX application. ¡ØIf the music phone connect to a PABX or key phone, then you have to dial the local number "9" in front of telephone number. Ex) If you want dial to 123-4567 2.RECEIVER UNIT:Same as a hand-set of normal telephone.(You can listen counter-partner's voice through receiver unit.)3.TALK/STAND-BY:If you press this button, it will be a TALK mode, which you can communicate with you counter- partner and press this button again, then it will go to STAND-BY mode.9RDPAUSE 123-45676.IN USE LAMP:To indicate the current status for TALK/STAND_BY 5.CHANNEL:You can select another empty channel while you are conversation with someone.
4.INSTALLATION¡ßConnect to the tel-line ¡ßConnect adapter to a power outlet ¡ßConnect to the computer1.Connect the adapter to the well power outlet. You must check the correct voltage before connection to your power outlet.2.Connect to the telephone line. 3.Switch ON in the hand-set unit ON/OFF switch. 3.Connect the 232C cable between computer and input/output jack of base unit correctly. 4.Place the hand-set unit on the base-set unit, then you can listen a beeper sound.5.CHARGING METHOD1.For the first using the music phone ¡ØThe battery is a kinds of consumer product and 6 months guarantee.¡ØThe battery efficiency reduce to an half, then you had better replace the battery.¡ØIf you do not use in a long time, you must disconnect battery from music phone.2.CHARGING Sometimes the battery already discharged during transporation,we recommend to charge more than 12 Hrs before use.* Check the "CHARGE" LED ON after place the hand-set unit on the hand-set unit.* 8HRs charging time is enough for charging the battery.* We recommend to place the hand-set unit on the base-set unit when you are sleep.6.MAKING A CALL2)How to receive a call from hand-set 1)How to make a call from hand-set ¨çWhen the hand-set unit does not place on the base-set unitAfter ring the bell, press any key and call¨èWhen the hand-set unit place on the base-set unitAfter ring the bell, pick-up the hand-set unit & call¡ØAfter call, please turn OFF the IN USE LAMP by pressing the TALK button¡ØAfter pick-up the hand-set unit from base-set unit, if you press the TALK key again, then you may be disconnect.¡ØThe bell will be ring 3~4 seconds delayed than normal telephone so we recommend to receive after ringing.Press the "TALK" button and check the dial tone sound, thendialing.
7.TROUBLE SHOOTING 8. CAUTIONS1)When you can not make conversation by pressing the TALK button of hand-set 1) Location of installation 2) Cautions 2)When you can not dial tone.3)When there is an interference and noise. 4)When the hand-set does nat ring? ¨çCheck if the power is conneted to the base-set unit properly.¨èCheck whether the telephone line of the base-set unit is connected correctly to the wall plug phone jack.¨éCheck hand-set unit whether the power ON/OFF switch is on position.¨êCheck if you press the TALK button after ringing at hand-set unit.¨ëPut the hand-set unit on the cradle of base-set unit at which you will hear a beep sound. If you can not hear this beep sound, please take out the hand-set unit and put on the cradle again until you get the beep sound.¨ìCheck if charging LED is lighting. When you get a warning tone for low battery, you must charge the battery fully. Do not install 900MHz Music phone at following places to usemore safely.¨ç Partitioned place with thick wall or steel beam structure. (Ex:Elevator )¨è Exposed place from heat or sunny place by directly.¨é Serious vibrating place or dusty or humidity place.¨çThe battery can be discharged which is normal condition at which set the power On/Off swich of hand-set to ON position then charge the battery fully(about 8 hour) before use.¨èWipe the charge contacts of base unit and hand-set with clear clothes regularly for better charging condition.¨éWhen you clean the Cabinet, use 2 or 3 drops of vinegar water, then it will prevent an electric discharge. Do not use benzene or alcohol when you clean the cabinet.¨êWhen you have a severe thunderstorm , you must pull out the power plug.¨ëAfter finishing of phone call, do not turn off the power swich of the hand-set. If you turn off, you can not receive the inco -ming call.¨ìIf you want not to use for a long period, we recommend to Turn off the Hand-set.¨çCheck if the charging Led is lighting in the hand-set.¨èMove the hand-set to the base unit more closely.¨éChange the location of base unit to other place.¨êMake sure that there is no obstacle near Music phone. (Ex:elevator, High power electric line, Electric game machine , or electric fish cage etc.)The telephone should ve installed gar from these equipments.¡ØIn case the unit does not work momentalily or can nat operate any button even though the power is being supplied, please pull-off the power plug and plug in againg.¨çPlease check the above points 1 again.¨èMove the hand-set unit to the base-set unit more closely.Please check the above points 1 and 2 againg.¨íWhen you hear a warning sound while you are making conver -sation and the charge Led is lightign, it means low battery so you must recharge the hand-set fully(more than 4 hours).¨îDo not dis-assemble.¨ïDo not install at humidity & wet place.¨ðAfter fully charged, you can use 3HRs on talk mode, 5HRs for audio listening mode and 12HRs at stand-by mode.

Navigation menu