RSI VIDEOTECHNOLOGIES MD00 Motion Detector User Manual

RSI VIDEOTECHNOLOGIES Motion Detector

User Manual

(EN) Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit English Français Deutsch  Remove battery before any maintenance!  WARNING, there is a risk of explosion if a battery is replaced by an incorrect type!  Observe polarity when setting up the batteries!  Do not throw used batteries! Bring them to your installer or a collection point.  Retirez les piles avant toute opération de maintenance !  Attention ! Il y a un risque d'explosion si l'une des piles utilisées est remplacée par une pile de type incorrect !  Respectez la polarité lors de la mise en place des piles !  Ne jetez pas les piles usagées ! Ramenez-les à votre installateur ou à un point de collecte spécialisé.  Batterien vor jeglichen Wartungsarbeiten entfernen!  Vorsicht, es besteht Explosionsgefahr, wenn eine Batterie durch eine Batterie falschen Typs ersetzt wird!  Achten Sie beim Einsetzen der Batterien auf die Polung!  Entsorgen Sie Batterien nicht im normalen Haushaltsmüll! Bringen Sie Ihre verbrauchten Batterien zu den öffentlichen Sammelstellen. FCC Regulatory Information for USA and CANADA FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI VideoTechnologies may void the FCC authorization to operate this equipment. FCC Part 15.105 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Cet appareil est conforme à la Partie 15 des règlementations de la FCC et avec la norme RSS-210 de l'Industrie Canadienne. Son fonctionnement est soumis aux deux conditions suivantes : (1) Cet appareil ne doit pas causer d'interférences nuisibles et (2) Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable.

Navigation menu