R F Technologies RF2000BP Beltpack Transceiver User Manual

R.F. Technologies, Inc. Beltpack Transceiver

Manual

RF2000BP OPERATING INSTRUCTIONSTERMS• Half Duplex: Combined speaker and mic at the menu board• Full Duplex: Separate speaker and mic at the menu board• Hands-Free: Automatic two-way communication (Talk and Listen) without touching the belt pack again (Operates in Full Duplex system only).ON/VOLUMECONTROL KNOBON/VOLUMECONTROL KNOBInnovative Solutions For the Drive-Thru IndustrySWITCH 4 = HANDS FREEENABLED = DOWN POSITIONDISABLED = UP POSITIONBATTERYCAVITYHEADSETSOCKETPOWER ON• Slide battery cover off, insert battery, slide batter cover on• Rotate on/volume control knob clockwise; power light goes on• Press and hold “A” button to talk to customer; release to listen • To talk to the customer again or to the next customer, press and hold the “A” button; release to listen• When vehicle exits, system becomes silentNOTE:HANDS-FREE DISABLED MODE: (Battery cavity upper dip switch #4 in UP Position)1• Press “A” button once to automatically Talk and Listen to customer (Power light blinks continuously in this mode)• When vehicle exits, the system becomes silent, but outbound audio will still be heard• Hands-Free is turned off when either the “A” or “B” button is pressed, or the belt pack is turned off• Press the “B” button and speak• Release the “B” button immediately after speaking since the “B” channel overrides the “A” channel and will cut out any ongoing communication with the customer.After a vehicle exits the drive-thru area, the inbound audio mutes. When the next car arrives, the vehicle-present tone is heard in the headset and two-way communication with the customer can begin.542 South Prairie StreetBethalto, IL 62010800.598.2370Office: 618.377.2654 Fax: 618.377.1320www.rftechno.comHANDS-FREE ENABLED MODE: (Battery cavity upper dip switch #4 in DOWN Position)(See reverse side for illustration)2OPERATING MODESTo communicate with other personnelwearing Belt Packs without being heard bythe customer:“B” BUTTON“A” BUTTONCompliance Statement (Part 15.19)This device complies with Part 15 of the FCC Rules.Operation is subject to the following two condition:1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may cause undesired operation.Warning (Part 15.21)Changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority tooperate the equipment.

Navigation menu