Primax Electronics M24702 Mouse User Manual 9847264

Primax Electronics Ltd Mouse 9847264

user manual

HP Wireless Optical ErgoMouseUser’s Manual© Copyright 2004 Hewlett-Packard Development Company, L.P.The information contained herein is subject to change without noticeThe only warranties for HP products and services are set forth in theexpress warranty statements accompanying such products andservices. Nothing herein should be construed as constituting anadditional warranty. HP shall not be liable for technical or editorialerrors or omissions contained herein.Part Number P2357AA #ABA07/2004: 07/22
FCC STATEMENT This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device mustaccept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC Rules. These limits are designed to provide reasonableprotection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, ifnot installed and used in accordance with the instruction guide, may cause harmful interference to radio communications. However, there is no guarantee that interference will notoccur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult a service representative for help.Properly shielded and grounded cables and connectors must be used in order to comply with FCC emission limits. Hewlett-Packard is not responsible for any radio or televisioninterference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes ormodifications could void the user’s authority to operate the equipment.For regulatory compliance information only, contact:Hardware Quality Eng. ManagerHewlett-Packard Company - CPC10500 Ridgeview CourtCupertino, CA95014Telephone: 1(408) 343-5000Tested To Comply With FCC StandardsFOR HOME OR OFFICE USEThis Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de classe B est conforme à la norme NMB-003 du Canada.
ContentsWelcome 4Installation 5Configuration 7Troubleshooting 8
WelcomeCongratulations on purchasing the HP Wireless Optical Ergo Mouse. This guide willprovide you with the necessary steps for installing and maintaining your mouse.Package ContentsHP Optical 4-Button USBMouseUSB Receiver CD with Driver/Software2 AA Batteries User’s Manual Warranty CardSystem Requirements• Available USB Port• CD-ROM Drive- 3 -
Compatible with Microsoft® Windows® 98SE/Me/2000/XPInstallationBattery InstallationSTEP 1 - Locate the 2 AA sized 1.5 Volt batteriesthat came with your HP Wireless Optical ErgoMouse.STEP 2 - Remove the battery compartmentcover located on the bottom of your mouse bypressing the tab forward.STEP 3 - Install the two batteries into the compartment, paying attention to properpolarities.STEP 4 - Close the battery compartment cover.Software InstallationInsert the CD into your CD-ROM drive. If the setup program does not appear, clickStart, then click Run. Type <drive letter>:\setup. Click OK. (For example, if the diskis in drive D, enter D:\Setup.) Follow the onscreen instructions.- 4 -
STEP 1 – Push the button on thereceiver once. The LED on thereceiver is continuously on.Hardware InstallationSTEP 1 - Power on your system.STEP 2 - Connect the USB receiver to any available USBport or hub connected to your computer.User SetupBy default your mouse works immediately. If the receiver and mouse are notsynchronized, perform the following procedureSTEP 2 – Push the button located on thebottom of the mouse, and then place themouse on the desk. The LED on thereceiver will now be off once your mouse issynchronized. When the mouse is in use,the LED on the receiver will blink.- 5 -- 6 -
ConfigurationYou can configure the buttons of this mouse to perform selected functions.Windows XP – Category ViewClick Start, select Settings / Control Panel /Printers and Other Hardware / Mouse, tocustomize your mouse settings.Windows 98SE, Me, 2000 and XP – Classic ViewClick Start, select Settings / Control Panel /Mouse, to customize your mouse settings.You can also click the mouse icon located inyour system tray to customize your mousesettings.When the software is installed, you will see the screen above when viewing yourmouse settings.- 7 -
Troubleshooting• If you have Windows 95 or Windows NT, these operating systems do notsupport this device.• The Universal Serial Bus Controller and USB root hub may not be properlyinstalled on your system. Contact your computer manufacturer for details.Technical SupportFor technical assistance call 1-866-314-7239 or visit www.microinv.com/hpTechnical Support hours of operation: Monday - Friday 8:30am to 10:00pm E.S.T.- 8 -

Navigation menu