OM Digital Solutions WP5 Wireless LAN Module User Manual S044WIFI PCA module Setup 20130422 2

Olympus Corporation Wireless LAN Module S044WIFI PCA module Setup 20130422 2

(Short-term Confidential) User Manual

S044WIFI-PCA Module2 䠊䠊䠊䠊Requirement to an Equipment (Camera) containing this module and its instruction manual for FCC and IC 1) The following sentence should be displayed on the equipment containing this module. "Contains Transmitter Module FCC ID: YSKWP5" or "Contains FCC ID: YSKWP5" "Contains Transmitter Module IC: 4763E-WP5" or "Contains IC: 4763E-WP5" 2) Industry Canada ICES-003 Compliance Label should be affixed on the equipment or instruction manual. Industry Canada ICES-003 Compliance Label:: CAN ICES-3 (B)/NMB-3(B) 3) The all following sentences should be written on an instruction manual of the equipment.FCC CAUTIONChanges or modifications not expressly approved by the party responsible for compliance could void the user’sauthority to operate the equipmentNote: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant topart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.Le présent appareil est conforme aux la partie 15 des règles de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage energy radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environmentand meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption ratio (SAR).Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnementnon contrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition dans leSupplément C à OET65 et d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement émet une énergie RF très faible qui est considérée conforme sans évaluation du débit d’absorption spécifique (DAS).㻞For OEM integration only – device cannot be sold to general public. Therefore we will not supply the User’s manual, the installation manual is the official for OEM.

Navigation menu