Nikko Co TP6731H Radio Controlled Toy (Transmitter) User Manual 1 of 2

Nikko Co Ltd Radio Controlled Toy (Transmitter) Users Manual 1 of 2

Contents

Users Manual 1 of 2

1Please read care ful ly before start ing to operate.l"Warning! use under the direct su per vi sion of an adult.Please read care ful ly before start ing to operate."Warning! use under the direct su per vi sion of an adult.Please read care ful ly before start ing to operate.KEEP THE DISPLAYBOX AND THE MANUAL FOR FUTURE REF ER ENCE.Use Ni-Cd battery pack(9.6V) and charger for this mod el.lllPRINTED IN CHINAIMPRIME EN CHINEIMPRESO EN CHINAEnglish/Français/EspañolllFEATURESlBATTERY REQUIREMENTSl2-channel full function: Forward, re verse, left/right turn and stop.2 speed in forward running2 speeds by transmitter op er a tionFront and rear suspension sys temRear wheel differential gearThe Headlights lightup when runningTransmitter: 1 x 9V(006P)battery 1 x NI-CD or NI-MH rechargeable bat tery pack(9.6 V) Vehicle:1/10 RADIO CONTROL STREET CARManual del PropietarioManuel du lutilisateurNOT RECOMMENDED FOR CHIL DREN UN DER 8 YEARS OF AGE. AS WITH ALL ELEC TRIC PROD UCTS, PRECAU-TIONS SHOULD BE OB SERVED DUR-ING HAN DLING AND USE TO PRE- VENT ELEC TRIC SHOCK.INPUT: 120VAC, 60HZ,OUTPUT: 12VDC, 200mAATTENTION PARENTSIt is recommended that this toy and all accessories be pe ri od i cal ly ex am ined for potential haz ards and that any po ten tial haz ard ous parts be re paired or re placed.CAUTION: ELECTRIC TOY* Recharge the Battery Before you Start to Operate* Recharger la batterie avant d’allumer* Recargue la bateria antes de em-pezar a jugarpezar a jugarOwner’s Manual:help@nikkoamerica.com:help@nikkoamerica.com:help@nikkoamerica.com:help@nikkoamerica.com:help@nikkoamerica.coml
2EnglishHousehold outlet1. Join the connector of the charger to the connector of the Ni-Cd battery pack (9.6 V).2. Plug the charger into an electrical out let.3. Recharge for about 4-5 hours.4. When the re charg ing is over, plug out the charger from the elec tri cal outlet and de-tach the con nec tors.CAUTION:nnnnnnnnnRECHARGINGChargerNi-Cd battery pack (9.6 V)Ni-Cd battery pack (9.6 V)PREPARATION FOR START ING OP ER A TION1. HOW TO ATTACH ANTENNA TUBEAntenna tubeAntenna wireAntenna tube holderPass the antenna wire through the antenna tube, then insert the tube into the an ten na tube holder.If the antenna tube cannot be suc- cess ful ly inserted into the antenna tube holder, try hold ing the root of the antenna wire with fingers of one hand and ex tend ing the wire with fin gers of the other hand.* Note: Be careful not to pull an- ten na wire too strong.Do not charge Battery Pack immediately after use.Wait until it is cooled before charging.Avoid short circuits. Short circuits will cause over-heating, burning of the cords and otherdamages to the Battery Pack and Charger.The Ni-CD Battery Charger should be used for charging one Battery Pack . Do not use thecharger for charging other types of batteries and battery packs.Do not use the Charger as a direct current outlet for other electrical appliances or machines.Make sure that the Battery Pack and Charger are kept out of the hands of infants and smallchildren while charging.Do not charge near fires, where the temperature is extremely high, or where it is wet or damp.The charger will become slightly heated while charging. Allow sufficient free space around theCharger.If the power of the battery pack is weak in spite of proper charging. The batteries may be worn out from repeated use. Replace it with a new Ni-CD battery pack.Dispose of use Ni-CD battery packs correctly.Disconnect the supply before making or breaking connections to the battery.WARNING AGAINST RECHARGING NON-RE-CHARGEABLE BATTERIES.Please use this battery charger only for the char-ger of the rechargeable battery pack.The NI-CD battery pack should be recharged un-der the supervision of an adult.nnnnOR* T h e n e w l y p u r c h a s e d N i - C d p a c k i s n o t charged.Recharge before operate.
3EnglishEnglishWhen installing a Ni-Cd battery pack, make sure that the power switch of the vehicle is OFF.VehicleJoin the connectors of the vehicle and the Ni-Cd pack.Battery compartment lid3. HOW TO INSTALL THE BAT TER IESEnglish3. HOW TO INSTALL THE BAT TER IESEnglishTo remove the battery lid, press the point marked “OPEN” and pull the lid down ward.One 9 volt (006P) batteryOne 9 volt (006P) batteryInstall battery making sure that (+) and (-) poles are positioned properly.* Dispose the used batteries sep a rate ly from other trash.Transmitter2. HOW TO INSTALL TRANS MIT TER AN TEN NAPlace the transmitter an ten na into the antenna hold er to screw it in clock- wise.Don’t install the antenna ex tend ed. It’s dangerous.If the antenna is not screwed in se- cure ly, the vehicle may move er rat i- cal ly. Screw the antenna securely.EnglishEnglishEnglishEnglishBattery stopperUse a coin to turn the battery stopper to the "OPEN" position.Let the battery compartment lid slide forward a little with a pressure on to the latch213
4EnglishFit the battery case into the battery com part ment of your vehicle and push in all the way. Press down the battery compartment lid when Use a coin to turn the battery stop-per When you con nect the con nec tors. make cer tain the ve hi cle switch is in the "OFF" po si tion.Set connectors properly.(The con nec tors are designed to be connected in only one way so that the pos i tive(+) and the neg a tive(-) ter mi nals are con nect ed ac cu rate ly.)Disconnect the connectors immediately af ter a run.When you disconnect the connectors, don't pull by the cords.Avoid short circuits because it is very dan ger ous.Remove all the batteries both from the ve hi cle and the transmitter after a run.HOW TO PLAYExtend the transmitter antenna.You can control the vehicle at a long er dis- tance by holding the trans mit ter higher with the an ten na straight up.Turn on the transmitter by op er at ing the con trol stick. (The pow er in di ca tor will light up.)Battery compartment545Battery's ConnectorVehicle's Connector21

Navigation menu