Nextivity orporated MBLE Bluetooth LE module User Manual 2

Nextivity Incorporated Bluetooth LE module Users Manual 2

Contents

Users Manual 2

PRODUCT INFORMATIONCel-Fi® PRO Smart Signal BoosterPRODUCT INFORMATIONCel-Fi PRO® Smart Signal BoosterIf you need help, visit: http://www.celhelp.comSafety Precautions• Use Cel-Fi indoors. It should not be used outdoors.• These products are designed to be used with a direct plug-in power supply unit that shipped with the product. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met.• There are no user serviceable parts inside.• CAUTION: Changes or modications to this product not expressly approved by Nextivity may void your right to operate the equipment.WarrantyNextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-.com/warranty.Limitation of LiabilityIn no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liable under contract, tort, strict liability, negli-gence or any other legal or equitable theory with respect to the Products or any other subject mat-ter of this Agreement (i) for any lost prots, cost of procurement of substitute goods or services, or special, indirect, incidental, punitive, or con-sequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextiv-ity from End User with respect to the Products actually purchased and paid for.See cel.com for list of patents covering this product. TrademarkCel-Fi, IntelliBoost, and Nextivity logo are trade-marks of Nextivity, Inc.FCC Statement (Applicable in the USA only) This is a CONSUMER device.BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some pro-viders may not consent to the use of this device on their network. If you are unsure, contact your provider.You MUST operate this device with approved antennas and cables as specied by the manu-facturer.Antennas MUST be installed at least 20 cm (8 inches) from any person.You MUST cease operating this device immedi-ately if requested by the FCC or a licensed wire-less service provider.WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 me-ters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC en-forcement action.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digi-tal device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi-If you need help, visit: http://www.celhelp.comSafety Precautions• Use Cel-Fi indoors. It should not be used outdoors.• These products are designed to be used with a direct plug-in power supply unit that shipped with the product. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met.• There are no user serviceable parts inside.• CAUTION: Changes or modications to this product not expressly approved by Nextivity may void your right to operate the equipment.WarrantyNextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-.com/warranty.Limitation of LiabilityIn no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liable under contract, tort, strict liability, negli-gence or any other legal or equitable theory with respect to the Products or any other subject mat-ter of this Agreement (i) for any lost prots, cost of procurement of substitute goods or services, or special, indirect, incidental, punitive, or con-sequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextiv-ity from End User with respect to the Products actually purchased and paid for.See cel.com for list of patents covering this product. TrademarkCel-Fi, IntelliBoost, and Nextivity logo are trade-marks of Nextivity, Inc.FCC Statement (Applicable in the USA only) This is a CONSUMER device.BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some pro-viders may not consent to the use of this device on their network. If you are unsure, contact your provider.You MUST operate this device with approved antennas and cables as specied by the manu-facturer.Antennas MUST be installed at least 20 cm (8 inches) from any person.You MUST cease operating this device immedi-ately if requested by the FCC or a licensed wire-less service provider.WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 me-ters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC en-forcement action.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digi-tal device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi-STOP!!! Do not call your service provider until you have read the Quick Start Guide.STOP!!! Do not call your service provider until you have read the Quick Start Guide.
Nextivity Inc Headquarters:12230 World Trade Drive Suite 250 San Diego, CA 92128, USA http://www.nextivityinc.comBureau in Europe:Whitehill Way, Swindon, UK SN5 6QRNextivity Inc Headquarters:12230 World Trade Drive Suite 250 San Diego, CA 92128, USA http://www.nextivityinc.comBureau in Europe:Whitehill Way, Swindon, UK SN5 6QRPI_PRO-NA-English_14-1104 PI_PRO-NA-English_14-1104dential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar-antee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equip-ment and receiver.• Connect the equipment into an outlet on a cir-cuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for helpIndustry Canada (IC) StatementThe Manufacturer’s rated output power of this equipment is for single carrier operation. For situ-ations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, es-pecially where the output signal is re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Gain 100dBBandwidth 35MhzInput and Output Impedances50 ohmOutput PowerUplink 22dBm per bandDownlink 16dBm per bandLe présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouil-lage est susceptible d’en compromettre le fonc-tionnement.Compliance ContactIn the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact in-formation is available at www.nextivityinc.com. PatentsThis product is covered by Nextivity, Inc., US patents and patents pending. Please refer to CEL-FI.com for details. CopyrightCopyright © 2014 by Nextivity, Inc. All rights re-served. Reproduction or media conversion by any means is protected by copyright and may only oc-cur with prior written permission of Nextivity. De-signed by Nextivity in California.dential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar-antee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equip-ment and receiver.• Connect the equipment into an outlet on a cir-cuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for helpIndustry Canada (IC) StatementThe Manufacturer’s rated output power of this equipment is for single carrier operation. For situ-ations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, es-pecially where the output signal is re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Gain 100dBBandwidth 35MhzInput and Output Impedances50 ohmOutput PowerUplink 22dBm per bandDownlink 16dBm per bandLe présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouil-lage est susceptible d’en compromettre le fonc-tionnement.Compliance ContactIn the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact in-formation is available at www.nextivityinc.com. PatentsThis product is covered by Nextivity, Inc., US patents and patents pending. Please refer to CEL-FI.com for details. CopyrightCopyright © 2014 by Nextivity, Inc. All rights re-served. Reproduction or media conversion by any means is protected by copyright and may only oc-cur with prior written permission of Nextivity. De-signed by Nextivity in California.

Navigation menu