Nextivity orporated G32-2451213 Provider-Specific Consumer Signal Booster User Manual

Nextivity Incorporated Provider-Specific Consumer Signal Booster

User Manual

If you need help, visit: www.cel-.com/support.Safety Precautions• These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met.• There are no user serviceable parts inside.• CAUTION: Changes or modications to this product not expressly approved by Nextivity may void your right to operate the equipment.WarrantyNextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-.com/warranty.Limitation of LiabilityIn no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liable under contract, tort, strict liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any lost prots, cost of procurement of substitute goods or services, or special, indirect, incidental, punitive, or consequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextivity from End User with respect to the Products actually purchased and paid for.See cel-.com for list of patents covering this product. TrademarkCel-Fi, IntelliBoost, and Nextivity logo are trademarks of Nextivity, Inc.This is a CONSUMER device.BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider.You MUST operate this device with approved antennas and cables as specied by the manufacturer.Antennas MUST be installed at least 20 cm (8 inches) from any person.You MUST cease operating this device immediately if requested by the FCC, Innovation, Science and Economic Development Canada or a licensed wireless service provider.WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.External Antenna:Only the antennas listed in the Antenna Kitting section of the Quick Start Guide are allowed to be used with Cel-Fi Smart Signal Boosters.FCC Statement (Applicable in the USA only) When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-tion against harmful interference in a residential installation. This equipment generates, uses and If you need help, visit: www.cel-.com/support.Safety Precautions• These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met.• There are no user serviceable parts inside.• CAUTION: Changes or modications to this product not expressly approved by Nextivity may void your right to operate the equipment.WarrantyNextivity Inc provides a limited warranty for its products. For details, please refer to http://cel-.com/warranty.Limitation of LiabilityIn no event shall Nextivity, nor its directors, employees, agents, suppliers or End Users, be liable under contract, tort, strict liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any lost prots, cost of procurement of substitute goods or services, or special, indirect, incidental, punitive, or consequential damages of any kind whatsoever or (ii) for any direct damages in excess of (in the aggregate) the fees actually received by Nextivity from End User with respect to the Products actually purchased and paid for.See cel-.com for list of patents covering this product. TrademarkCel-Fi, IntelliBoost, and Nextivity logo are trademarks of Nextivity, Inc.This is a CONSUMER device.BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider.You MUST operate this device with approved antennas and cables as specied by the manufacturer.Antennas MUST be installed at least 20 cm (8 inches) from any person.You MUST cease operating this device immediately if requested by the FCC, Innovation, Science and Economic Development Canada or a licensed wireless service provider.WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.External Antenna:Only the antennas listed in the Antenna Kitting section of the Quick Start Guide are allowed to be used with Cel-Fi Smart Signal Boosters.FCC Statement (Applicable in the USA only) When used with any mobile device utilizing the 1710-1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-tion against harmful interference in a residential installation. This equipment generates, uses and STOP!!! Do not call your service provider until you have read the Quick Start Guide.STOP!!! Do not call your service provider until you have read the Quick Start Guide.PRODUCT INFORMATIONCel-Fi™ GO M Smart Signal Booster™PRODUCT INFORMATIONCel-Fi™ GO M Smart Signal Booster™
legal_GO-M-Eng_17-0302 legal_GO-M-Eng_17-0302can radiate radio frequency energy and, if not installed and used in accordance with the instruc-tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equip-ment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for helpISED STATEMENTBEFORE USE, meet all requirements set out in CPC-2-1-05.This device may operate in a xed location only, for in-building use.In order to comply with ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times.An de se conformer aux exigences d’exposition RF de ISED, cet appareil doit être installé pour fournir au moins 20 cm de séparation du corps humain en tout temps. The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.[FRENCH: La puissance de sortie nominale indiquée par le fabricant pour cet appareil concerne son fonctionnement avec porteuse unique. Pour des appareils avec porteuses multiples, on doit réduire la valeur nominale de 3,5dB, surtout si le signal de sortie est retransmis et qu’il peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle réduction doit porter sur la puissance d’entrée ou sur le gain, et ne doit pas se faire au moyen d’un atténuateur raccordé à la sortie du dispositif.]This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.[FRENCH: Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.]Gain 58dB (=<1GHz)65dB (>1GHz)Bandwidth 75MhzInput and Output Impedances50 ohmOutput PowerUplink 22dBm per bandDownlink 16dBm per bandCompliance ContactIn the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com.PatentsThis product is covered by Nextivity, Inc., US patents and patents pending. Please refer to cel-.com for details.CopyrightCopyright © 2017 by Nextivity, Inc. All rights reserved. Reproduction or media conversion by any means is protected by copyright and may only occur with prior written permission of Nextivity. Designed by Nextivity in California.can radiate radio frequency energy and, if not installed and used in accordance with the instruc-tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equip-ment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for helpISED STATEMENTBEFORE USE, meet all requirements set out in CPC-2-1-05.This device may operate in a xed location only, for in-building use.In order to comply with ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times.An de se conformer aux exigences d’exposition RF de ISED, cet appareil doit être installé pour fournir au moins 20 cm de séparation du corps humain en tout temps. The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.[FRENCH: La puissance de sortie nominale indiquée par le fabricant pour cet appareil concerne son fonctionnement avec porteuse unique. Pour des appareils avec porteuses multiples, on doit réduire la valeur nominale de 3,5dB, surtout si le signal de sortie est retransmis et qu’il peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle réduction doit porter sur la puissance d’entrée ou sur le gain, et ne doit pas se faire au moyen d’un atténuateur raccordé à la sortie du dispositif.]This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.[FRENCH: Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.]Gain 58dB (=<1GHz)65dB (>1GHz)Bandwidth 75MhzInput and Output Impedances50 ohmOutput PowerUplink 22dBm per bandDownlink 16dBm per bandCompliance ContactIn the event of regulatory compliance issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com.PatentsThis product is covered by Nextivity, Inc., US patents and patents pending. Please refer to cel-.com for details.CopyrightCopyright © 2017 by Nextivity, Inc. All rights reserved. Reproduction or media conversion by any means is protected by copyright and may only occur with prior written permission of Nextivity. Designed by Nextivity in California.Bureau in Europe:Unit 6, Basepoint Business CentreRivermead Drive, WestleaSwindon SN5 7EXU.S. Headquarters: Nextivity Inc.16550 West Bernardo Drive Bldg. 5, Suite 550 San Diego, CA 92127, USA+1 858.485.9442 tel+1 858.485.9445 faxwww.cel-.comNextivity Singapore Pte. Ltd.:2 Changi Business Park Avenue 1Level 2 – Suite 16,486015 SingaporeBureau in Europe:Unit 6, Basepoint Business CentreRivermead Drive, WestleaSwindon SN5 7EXU.S. Headquarters: Nextivity Inc.16550 West Bernardo Drive Bldg. 5, Suite 550 San Diego, CA 92127, USA+1 858.485.9442 tel+1 858.485.9445 faxwww.cel-.comNextivity Singapore Pte. Ltd.:2 Changi Business Park Avenue 1Level 2 – Suite 16,486015 Singapore

Navigation menu