Nextivity orporated CELFI-RSWU104 Cel-Fi Residential System User Manual Basic CMYK

Nextivity Incorporated Cel-Fi Residential System Basic CMYK

Contents

420N001-001-10R51 small

2 StepQuick Start GuideThe Cel-Fi Window Unit takes the strongest cell signal in your homeand distributes it throughout via the Coverage UnitMobile signalbefore installationMobile signalafter installationPATENT 7,519,323Power o(no green light)Status redStatus ashing redStatus ashing green for more than a minute1. Is the Unit plugged in?2. Is there power to the outlet?3. Try exchanging power supplies with the other unit to see if the power supply is defective.1. Unplug the unit, wait a few minutes, and try again.2. Visit the installation support section at: www.celhelp.com for more information.1. Do not cover the Unit or block the vents.2. Move the Unit to a cooler spot.3. The unit will start operating again when it cools.1. Wait longer. System is verifying regulatorycompliance. This could take up to 30 minutes.2. Make sure Units are not next to a Wi-Fi router.Indicator    Problem              Try this:Trouble Shooting Guide(((            ))) (((            ))) If there is a system fault, the Coverage Unit will display an error message on the display in the location where the coverage number is usually displayed (see below).If this occurs the message will alternate between displaying an “E” (for error) and then a number.The table below shows what values will be displayed and what they mean.“E1”             Window Unit cannot nd the network      Make sure you have one bar coverage on Window Unit.“E2”             Window Unit has interference        Make a test call. If you can’t, move the Window Unit.“E3 or E4”       Environment is too warm for Unit       System will operate again when it cools.COVERAGE NUMBERCommon IndicatorsCoverage Unit Window Unit Error MessagesThe Cel-Fi Window and Coverage Units have Power and Status indicator lights to help you determine how the Units are operating and how to obtain the best coverage within your home.StatusPower SignalindicatorsThere is no power to the Unit.There is a problem with Cel-Fi.The Unit has switchedto a low power modebecause the environ-ment is too warm.The Unit is taking longer than normal to make a link.No green bars 1. Try moving the Window Unit to another roomwhere you have better mobile phone coverage.(Use your mobile phone to nd the best location.)1. Move the Coverage Unit closer tothe Window Unit.1. Move the Coverage Unit farther away from the Window Unit.The Coverage Unit istoo far away from the Window Unit. The Coverage Unit is too close to the Window Unit  420N001-001-10R51
Step1: Setup the Window Unit Step2: Setup the Coverage UnitLocate the best 3G signal within your home and plug the Window Unit into the nearest power outlet.  (Look for the 3G icon on your mobile phone). Placing the Window Unit near a window is best.Set Coverage Unit near the middle of your home and plug it into the nearest outlet. Wait until the status light stops ashing. You should see this on the Coverage Unit indicator panel.If the indicator looks like this, move the Coverage Unitaway from the Window Unit.If the indicator looks like this, move the Coverage Unitcloser to the Window Unit.COVERAGE UNIT INDICATOR PANELWINDOW UNITCOVERAGE UNITSignalindicatorLocationindicatorsWINDOW UNITFOOT, WALL MOUNT AND POWER ADAPTERSCOVERAGE UNITWINDOW UNITCOVERAGE UNITThe larger this number, the better your coverage.SIGNAL BAR INDICATORLocated in the middleof the Window Unit.NEED HELP?Visit www.celhelp.com for an installation video and other helpful information regarding the installation and trouble shooting of your systemAB CNote:If you do not see at least one barin the signal indicator window(as on left), move the unit closer to a window or try another room.Upstairs is best if available.PRESS THEWINDOW UNIT ONTO THE FOOTStatusPowerStatusPower

Navigation menu