NEOSEN ENERGY NEO-033 Ventev Wireless Chargers User Manual ventev miniPro window instruction card V2

NEOSEN ENERGY Ventev Wireless Chargers ventev miniPro window instruction card V2

15_594000 UserMan

DISCLAIMER: The sticky suction mount is only recommended for hard, flat surfaces. A semi-permanent or permanent indentation may occur if used on surfaces made of soft leather, vinyl, or similar materials. Ventev is not responsible for any damages caused to your dashboard due to the installation or use of the sticky suction mount. Do not install any mount or holder over an airbag cover or within the airbag deployment zone.use the tightening ring to create a firm fitattach mount to minipro:insert phone by pushing latchesoutwardsinsert phonespring loaded latch fits devices from 2.125” (54mm) to 3.875” (98 mm) wideadjustable latch:minipro window installation instructions3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M
minipro window instrucciones de instalación | instructions d'installationwindow mountconecte el soporte al minipro: | fixer le support à minipro:apriete al anillo para reforzar el ajuste: | utiliser la bague de serrage pour un ajustement fermeminiball(soporte adhesivo | support adhésif)Inserte el teléfono en el minipro empujando los brazos hacia afuerainsérer le téléphone en ouvrant le loquetsinserte el teléfonoinsérer le téléphoneel pestillo tiene resorte adjustable a tamaño 2.125” (54mm) hasta 3.875” (98 mm) de anchole loquet à ressort est compatible avec des appareils d'une largeur de 2,125" (54mm) à 3,875" (98 mm)pestillo ajustable:loquet ajustable:AVISO: El soporte succión pegajosa solamente se recomienda para uso con superficies plana y dura. Una abolladura podra ocurrir si la superficial esta hecha de piel, vinilo o materiaesl simiar. Ventev no es responsable por daño causado al la supericies del vehículo por uso del soporte succión pegajosa. No instale soportes cerca or encima de bolsas de aire o zona de despliegue.AVERTISSEMENT : Le support à fixation par succion est recommandé uniquement sur des surfaces dures et plates. Peut laisser une marque semi-permanente ou permanente si utilisé sur des surfaces en cuir souple, vinyle ou matériaux similaires. Ventev n'est pas responsable des dommages causés à votre tableau de bord en raison de l'installation ou de l'utilisation du support à fixation par succion. Ne pas installer de support ou fixation de téléphone sur le couvercle du coussin gonflable ou dans la zone de déploiement du coussin gonflable.3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M 3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M3M 3M
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu