NEC of America 7N2P14 PCS GSM Phone with RFID User Manual RF Warning Page

NEC Corporation of America PCS GSM Phone with RFID Users Manual RF Warning Page

Contents

Users Manual RF Warning Page

1Radio Frequency (RF) SignalsTHIS MODEL PHONE MEETS THE U.S. GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIOWAVES.Your wireless phone contains a radio transmitter and receiver. Your phone is designed and manufactured not toexceed the emission limits for exposure to radio frequency (RF) energy set by the Federal CommunicationsCommission of the U.S. Government. These limits are part of comprehensive guidelines and establishpermitted levels of RF energy for the general population. The guidelines are based on standards that weredeveloped by independent scientific organizations through periodic and thorough evaluation of scientificstudies.The exposure standard for wireless mobile phones employs a unit of measurement known as the SpecificAbsorption Rate (SAR). The SAR limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted usingstandard operating positions accepted by the FCC with the phone transmitting at its highest certified powerlevel in all tested frequency bands. Although the SAR is determined at the highest certified power level, theactual SAR level of the phone while operating can be well below the maximum value. This is because thephone is designed to operate at multiple power levels so as to use only the power required to reach thenetwork. In general, the closer you are to a wireless base station antenna, the lower the output.Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it doesnot exceed the limit established by the U.S. government-adopted requirement for safe exposure. The tests areperformed on position and locations (for example, at the ear and worn on the body) as required by FCC foreach model. The highest SAR value for this model phone as reported to the FCC when tested for use at theear is 0.946 W/kg, and when worn on the body, is 0.412 W/kg. (Body-worn measurements differ among phonemodels, depending upon available accessories and FCC requirements). While there may be differencesbetween the SAR levels of various phones and at various positions, they all meet the U.S. governmentrequirement.The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluatedas in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with theFCC and can be found under the Display Grant section at https://gullfoss2.fcc.gov/oetcf/eas/reports/GenericSearch.cfm after search on FCC ID A98-7N2P14.For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when usedwith an accessory designated for this product or when used with an accessory that contains no metal and thatpositions the handset a minimum of 1.5 cm from the body.* In the United States, the SAR limit for wireless mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. SAR values may vary depending upon national reporting requirements and the network band.ODN_FCC.book 1 ページ ２００８年４月１７日　木曜日　午後７時１６分
2FCC RegulationsThis mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.ODN_FCC.book 2 ページ ２００８年４月１７日　木曜日　午後７時１６分

Navigation menu