NEAT Electronics 1400304 Radio Pendant User Manual SMILE 100x106

NEAT Electronics AB Radio Pendant SMILE 100x106

User manual

DraDraft, not for public use Output date: 2015-12-14Portable transmitterUser manualSMILE NE41 14002-02 v1.0
DraDraDraft, not for public use Output date: 2015-12-14Draft, not for public use Output date: 2015-12-142 3SMILE User manual NE41 14002-02 v1.0 SMILE User manual NE41 14002-02 v1.0Intended use 3General funcons 3SMILE Parts 4Handling and operaon 4Mounng 4Mounng/unmounng the PIN/necklace 4Mounng the wristband 4Mounng the CLIP 5Mounng the HAPA 5Important 5Safety Notes 5Use 5Cleaning 6Disposal 6Technical Data Intended useSMILE is intended for use in homes and wardens to provide a feeling of security with the possibility to dispatch alarms in the event of an accident.General funconsSMILE is a portable trigger which must be connected to a receiver (e.g. NEO Homecare Phone, TREX2G Portable Transceiver, D-TECT and D-SERVER System) to be able to send alarms.The alarm is trigged by a light touch on the red alarm buon and the alarm is acknowledged by blinking green.EU NotesNEAT Electronics declares that this mobile device, type SMILE, is in compli-ance with the essenal requirements and other relevant provisions:Direcve: 1999/5/CE (RTTE), 2004/108/EC (EMC), 2006/95/EC (LVD)Standards: EMC: EN 301 489-1 V1.8.1 (2008) EN 301 489-3 V1.4.1 (2002)Radio: EN 300 220-2 V2.3.1 Category IIILow Voltage: EN 60950-1:2006+A11:2010US NotesFCC ID: 2AGLF1400304Changes or modicaons not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This device complies with part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) This device may not cause harmful interfer-ence, and (2) this device must accept any interference received, including interference that may cause undesired operaon.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separaon between the equipment and receiver.• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Ulrik Lundberg Managing directorInformaon in this User manual is subject to change without noce.NEAT Electronics AB reserves the right to change or improve their products and to make changes to the content without obligaon to nofy any person or organizaon of such changes or improvements.NEAT Electronics AB is not responsible for any loss of data, income or any consequenal damage whatsoever caused.For more informaon, details and descripons, visit our web site:www. neat-group.com/se/en© NEAT Electronics AB 2015All rights reserved.Document number: NE41 14002-02 v1.0Revision date: 2015-12-14NEAT Electronics AB Varuvägen 2 SE-24642 Löddeköpinge SwedenPhone:+46 (0)46 707065Fax: +46 (0)46 707087www.neat-group.com/se/eninfosweden@neat-group.comContents
DraDraDraft, not for public use Output date: 2015-12-14Draft, not for public use Output date: 2015-12-1445SMILE User manual NE41 14002-02 v1.0 SMILE User manual NE41 14002-02 v1.0SMILE Parts④① ② ③#Denominaon①SMILE Unit (with red alarm buon)②SMILE PIN (with latch and necklace)③SMILE CLIP (Oponal)④SMILE Handicap Adaptor (Oponal)SMILE Wristband (not displayed)SMILE BerlockThe SMILE Unit, Wristband and Pin are included in a standard SMILE Kit while the CLIP and HAPA are oponal accessories.Handling and operaonPress the red alarm buon to transmit an alarm.MounngMounng/unmounng the PIN/necklace②①Thread the pin into the holes and press unl the latch clicks into place.Release the pin by pressing the latch ① and then pulling it upwards ②.Mounng the wristbandThread the wristband through the holes and aach on arm.Mounng the CLIPFix CLIP on the back of the SMILE, thread the PIN trough the holes on the SMILE unl the latch clicks in place.To detach the CLIP, press the PIN latch and remove the PIN.Mounng the HAPAGently press the HAPA to the front of the SMILE.To detach, use a thin blade (e.g. a table knife or similar) insert under the HAPA and gently bend the hooks from SMILE.Do not use excessive force or the hooks may break.This secon intenonally le blank
DraDraft, not for public use Output date: 2015-12-14DraDraft, not for public use Output date: 2015-12-146SMILE User manual NE41 14002-02 v1.0ImportantSafety Notes• Read instrucons prior to use• Always test the system per instrucons prior to use and always check the funcon of the product aer making adjustmentsThis product may not be suitable for all persons.• This product should not be a substute for the roune visual monitoring protocol by caregiver and must not be used in situaons where a delay in the arrival of ap-propriate medical care, could lead to a potenally life-threatening situaon.• Our units are NOT intended for any life support device, thus intending a device whose malfunc-on may result in damage to a life.• Check the device regularly and replace when necessary.• Do not integrate to other systems other than those specied in this document.• The product will not cause electromagnec disturbances under normal working condions.• The product can be placed near other products or devices as long as mechanical vibraon is not present.Use• Use only original parts.• Keep away from dust, moist and dirt.• Do not drop, knock, twist or shake the device.• Do not warm up the device or use it near re.• The product may not be painted.• For repairs, contact a NEAT dealer.Cleaning• All parts in the product kit can be cleaned with a mild soap soluon and a damp cloth. Dry with a dry cloth.• Strong chemicals, grease and other harsh substances must not be used when cleaning or handling the parts in the product kit.• Aer cleaning, control that the product works properly by sending a test alarm to the alarm receiver/central.DisposalAt the end of the product’s use life, please dispose of it at appropriate collecon points provided in your country. For disposal or recycling informa-on, please contact your local authories or the Electronic Industries Alliance (EIA, www.eiae.org). In the European Union, the bin label indicates that this product should not be disposed of with household waste. It should be deposited at an appropriate facility to enable recovery and recycling or returned to NEAT Electronics.Technical DataMeasure 34 x 42 x 15 mmWeight (incl. baery) 14 gRF Frequency EU US869.2 MHz (Social alarms)916.2 MHzBaery life TBDIP Class TBDTemperature range +5 - +55 °CApprovals TBD
DraDraft, not for public use Output date: 2015-12-14www.neat-group.com/se/en

Navigation menu