Motorola Solutions 89FT7088 Video Speaker Microphone User Manual MN002719A01 2 en

Motorola Solutions, Inc. Video Speaker Microphone MN002719A01 2 en

Manual

m Foreword RF Energy Exposure and Product Safety Guide for Portable Two-Way VSMATTENTIONThe Si Series Video Speaker Microphones (VSMs) are ONLY compatible and certified when used with ASTRO APX and TETRA MTP Radio Models. A Radio firmware upgrade may be required to support colaborative operation. Before using this product, read the RF Energy Exposure and Product Safety Guide that shipped with the Radio which contains instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulation. This equipment is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. For body worn operation, this device has been tested and meets the FCC RF exposure guideline for use with a Motorola Solutions, Inc. approved accessories sold with this device.Use of non-Motorola-approved body worn or battery accessories may exceed the applicable RF exposure guidelines (iEEE, ICNIRP or FCC).This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by Motorola may void the user’s authority to operate this device. This class B digital apparatus complies with Canadian ICES-003.Under Industry Canada regulations, this microphone transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.This device complies with Industry Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept anyinterference, including interference that may causeundesired operation. Frequency of operation - IC 5 GHz only• The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.Radio Frequency Interference Requirements - FCCNote: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a res-idential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harm-ful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-ence to radio or television reception, which can be deter-mined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna• Increase the separation between the equipment and receiver• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.WarrantyMotorola Solutions warrants the Si Series device and accessories for One (1) year.  Please contact Motorola at 1-800-927-2744 US/Canada for any product related questions.VSM Overview                                               User Interface Installing and Removing BatteryInstalling1. Insert the battery into the open slot, sliding up until it locks securely in place.Removing1. Turn OFF the VSM.2. Press the two buttons located on the bottom of the battery to unlock and release the batteryPower OnThe light will show solid Green briefly upon power up and then turn off to indicate successful power up. Please contact Motorola Solutions Customer Care at 1 800 422 4210 if the light remains Green for more than one minute.NOTE: The light will not activate if the VSM is in Covert mode. When operating in Covert Mode, all tones, LED's, and display indicators are not active. Volume SwitchNOTE: A single press of the volume switch increases or decreases the volume by one step.Charging the Device2 methods to charge the Si Series device:1. Direct connection of the travel charger into the Micro USB port2. Drop-in charging via the Multi Unit Charger via 2 side contacts on the Si Series device.Connecting your Si Series DeviceThe Si Series device may be connected via a traditional wire, or wirelessly (Si500 model only)  if your VSM is BlueTooth enabled and configured by your administrator.Wired Connection1. Connect the wire by attaching to the bottom of your Si Series device, and secure with two thumb-screws within the cable connector.2. Connect to the VSM connector on the side of your VSM by removing the dust cover if attached, and secure with the thumbscrew on the bottom of the connector.CameraThe Si Series offers a 210 degree articulating camera. Rotate the camera based on preferred device wearing position and user heightRecording VideoSlide the Manual Slider on the side of the device upto start recording, and down to stop recording.Your Si Series device may also start videorecording automatically via an emergency buttonpress on the Si Series device or your VSM, ifconfigured by your Administrator.Programmable ButtonsNOTE: The top orange button will initiate an emergency signal and automatically start video recording, if configured by your Administrator.Wearing the Si Series DeviceThe carry holder offers a rotating belt clip, and allows the device to be flexibly worn with speaker face in or face out. The optional Shoulder Strap is used in conjuc-tion with the Carry Holder to enable lapel wear using a uniform or tactical vest epaulette.  Adaptive Audio technology (standard on Si500, optional on Si300) reduces wind and ambient noise.  Press the PTT and speak normally - there is no need to tilt or turn your head to the microphone.Best position to wear the Si VSM1. Worn on the left shoulder (upright or inverted) with head angled such that mouth is towards the microphone arrays.2. Worn at the center of the chest (upright or rotated +/- 90deg) with head angled such that mouth is towards the microphone arrays.Handling PrecautionsThe Si VSM meets IP67 specifications, allowing the VSM to withstand adverse field conditions such as being exposed to water or dust.• Keep your device clean and exposure to water should be avoided to help ensure optimal functionality and performance.• To clean the exterior surfaces of the VSM, use a diluted solution of mild dishwashing detergent andfresh water (i.e. one teaspoon of detergent to one gallon of water).• These surfaces should be cleaned whenever a periodic visual inspection reveals the presence ofsmudges, grease, and/or grime.Caution: The effects of certain chemicals and their vapors can have harmful results on certain plastics. Avoid using aerosol sprays, tuner cleaners and other chemicals.LED(2)(1)ManualSliderProgrammable Buttons Default* Covert mode is used during tactical situations, it disables the display, all tones and LED’s.Action Short Press Long PressProg.Button 1- Video Preview (Si500)- Audio Mute when Recording (Si300)Audio RecordingProg.Button 2Photo Capture/Media Mark (Si300 and Si500)Covert Mode*Emegency ButtonForward to Radio Forward to RadioSi500 Display and Si300 Non Display Video Speaker MicrophoneAccessories*MN002719A01*MN002719A01-AAenfr-CAes-LApt-BRMOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. © 2016 Motorola Solutions, Inc. All rights reserved. CameraPower ButtonLCD Display(Home Panel)MicrophoneSpeakerVolumeControlPTTButtonProgrammableButton 1EmergencyButtonAccessoryConnectorManual Slider (Video)ChargingContactsProgrammableButton 2ChargingContactsStatus LEDCamera LEDConversational PanelActivity PanelPrinted in

Navigation menu