Motion Access MATRIX Door Radio Control User Manual

Motion Access LLC Door Radio Control Users Manual

Users Manual

MATRiXTransmitter / ReceiverMOTIONACCESS, LLCautomatic entrance solutionsFor technical assistance call 866-357-8832MAXTRiX_MNL_revBTransmitter: MAX-TX Transmitter: MAX-TXReceiver: MAX-RXFrequency CodeSignalOutputSequenceDelay2ONSet SignalOutput dipswitch #2 toON (up).Switch #1 isnot used.Set the 12 Frequency Code switches to the desiredpositions. This code must match the ReceiverFrequency Code. Note: Dip switch "UP" is "ON".121Receiver: MAX-RXFrequency CodeSignalOutputSequenceDelay2ONSet SignalOutput dipswitch #2 toOFF (down).Switch #1 isnot used.Set the 12 Frequency Code switches to the desiredpositions. This code must match the Receiver "A"Frequency Code. Note: Dip switch "UP" is "ON". TheReceiver "B" Frequency Code is the same as "A"except with switch #2* in the opposite position.121Set the Sequence Delay to the desired time betweendoor "A" & "B" activations. The range of thispotentiometer is 1-20 seconds.2*common10-36Vac/8-25Vdc10-36Vac/8-25VdcNormally ClosedNormally OpenHold ONTimeFrequency CodeON121Match the 12 Frequency Code switches to theTransmitter Frequency Code. Note: Dip switch"DOWN" is "ON".Set the Hold ON Time to thedesired duration of the activationsignal. The range of thispotentiometer is 1-20 seconds.Notes: The receiver antenna must protrude through theoperator housing. The maximum relay capacity is 1A @120Vac / 30Vdc.Frequency CodeON121common10-36Vac/8-25Vdc10-36Vac/8-25VdcNormally ClosedNormally OpenHold ONTimeSet the Hold ON Time to thedesired duration of the activationsignal. The range of thispotentiometer is 1-20 seconds.*For Receiver "A", match the 12 Frequency Codeswitches to the Transmitter Frequency Code. Note:Dip switch "DOWN" is "ON". The Receiver "B"Frequency Code will be the same as "A" exceptwith switch #2* in the opposite position.2The Sequence Delay is not used for single doors. It isonly used for sequenced doors.111 12 23 3445 5Changes or modifications not expressly approved by MotionAccess could void the user's authority to operate the equipment. This devicecomplies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmfulinterference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Notes: The receiver antenna must protrude through theoperator housing. The maximum relay capacity is 1A @120Vac / 30Vdc.2) Sequenced Doors Setup1) Single Door Setup

Navigation menu