Mikrotikls SIA RB941-2ND Digital Transmission System User Manual 1

Mikrotikls SIA Digital Transmission System 1

Contents

User Manual 1

Federal Communication Commission InterferenceStatement (FCC ID: TV7RB941-2ND)This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one of the following measures:•Reorient or relocate the receiving antenna.•Increase the separation between the equipment and receiver.•Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.•Consult the dealer or an experienced radio/TV technician for help.FCC Caution: Any changes or modifications not expressly approved by the party responsiblefor compliance could void the user’s authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device mustaccept any interference received, including interference that may cause undesired operation.This device and its antenna must not be co-located or operation in conjunction with any otherantenna or transmitter.IMPORTANT: Exposure to Radio Frequency Radiation.20 cm minimum distance has to be maintained between the antenna and user. Under suchconfiguration, the FCC radiation exposure limits set forth for an population/uncontrolledenvironment can be satisfied.Antenna Installation. WARNING: It is installer's responsibility to ensure that when usingthe authorized antennas in the United States (or where FCC rules apply); only those antennascertified with the product are used. The use of any antenna other than those certified with theproduct is expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installershould configure the output power level of antennas, according to country regulations and perantenna type. Professional installation is required of equipment with connectors to ensurecompliance with health and safety issues. Industry Canada (IC:7442A-9412ND) This device complies with Industry Canada licence-exempt RSS standard(s). Operation issubject to the following two conditions: (1) this device may not cause interference, and (2)this device must accept any interference, including interference that may cause undesiredoperation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareilsradio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter toutbrouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre lefonctionnement.

Navigation menu