Microhard Systems IPN4GNBG30 IPn4G 4G LTE Cellular Ethernet Bridge/Serial Gateway User Manual User guide

Microhard Systems Inc IPn4G 4G LTE Cellular Ethernet Bridge/Serial Gateway User guide

User guide

IPn4G IPn4G LTE Ethernet Bridge/Serial Gateway Document: IPn4G User Guide.v1.0.pdf User Guide December 2012 150 Country Hills Landing NW Calgary, Alberta Canada T3K 5P3 Phone: (403) 248-0028 Fax: (403) 248-2762 www.microhardcorp.com
© Microhard Systems Inc. 2 Revision History Revision Description Initials Date 1.0 Initial Release PEH Dec 2012
FCC/ICRegulatoryNoticeModificationstatement:MicrohardSystemsInchasnotapprovedanychangesormodificationstothisdevicebytheuser.Anychangesormodificationscouldvoidtheuser’sauthoritytooperatetheequipment.Interferencestatement:ThisdevicecomplieswithPart15oftheFCCRulesandIndustryCanadalicence‐exemptRSSstandard(s).Operationissubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseinterference,and(2)thisdevicemustacceptanyinterference,includinginterferencethatmaycauseundesiredoperationofthedevice.RadiationExposureStatement:IPn4GcomplieswithFCC/ICradiationexposurelimitssetforthforanuncontrolledenvironmentandmeetstheFCCradiofrequency(RF)ExposureGuidelinesinSupplementCtoOET65andRSS‐102oftheICradiofrequency(RF)Exposurerules.Nevertheless,theproductshouldbeusedinsuchamannerthatthepotentialforhumancontactduringnormaloperationisminimized.Thisequipmentshouldbeinstalledandoperatedwithminimumdistanceof20cmbetweentheradiatorandanypersonandmustnotbecollocatedwithothertransmittersexceptotherwiseauthorised.Thisdeviceisapprovedtobeusedwithadipoleantennawithamaximumgainof2dBi.Thisproductintegratesandisauthorizedtobeco‐locatedwithaNovatelWireless'Expedite®E371PCIExpressMiniCard(FCCID:PKRNVWE371,IC:3229A‐E371).TheNovatelWireless'Expedite®E371PCIExpressMiniCardisgrantedwithamodularapprovalformobileapplications.Integrationhasbeendonemeetingthefollowingconditions:1.Atleast20cmseparationdistancebetweentheantennaandanypersonbodyismaintainedatalltimes.2.TocomplywithFCC/ICregulationslimitingbothmaximumRFoutputpowerandhumanexposuretoRFradiation,themaximumantennagainincludingcablelossinamobileonlyexposureconditiondoesnotexceed3.5dBifor850MHzfrequencyband,5.0dBifor700MHzfrequencyband,5.0dBifor1700MHzfrequencybandand3.0dBifor1900MHzfrequencyband.3.TheNovatelWireless'Expedite®E371PCIExpressMiniCardantennaisnotco‐locatedwithanyotherantennasexceptwiththeantennaoftheIPn4Gproduct.FCCClassBdigitaldevicenoticeThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttopart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.Thisequipmentgenerates,usesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththeinstructions,maycauseharmfulinterferencetoradiocommunications.However,thereisnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescauseharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipmentoffandon,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures:‐ Reorientorrelocatethereceivingantenna.‐ Increasetheseparationbetweentheequipmentandreceiver.‐ Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.‐ Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
FCC/ICAvisréglementaireInstructiondemodification:MicrohardSystemsIncn'apasapprouvélesmodificationsapportéesàcetappareilparl'utilisateur.Leschangementsoumodificationspourraientannulerl'autoritédel'utilisateuràutilisercetéquipement.Déclarationsurlesinterférences:CetappareilestconformeàlaPartie15delaréglementationFCCetIndustrieCanadaexemptsdelicenceRSSnorme(s).Sonfonctionnementestsoumisauxdeuxconditionssuivantes:(1)cetappareilnedoitpasprovoquerd'interférences,et(2)cetappareildoitacceptertouteinterférence,ycomprislesinterférencespouvantprovoquerunfonctionnementindésirabledel'appareil.Déclarationd'expositionauxradiations:IPN4Gestconformeàl'expositionauxradiationsFCC/ICdéfiniespourunenvironnementnoncontrôléetrépondauxdirectivesd'expositiondelafréquencedelaFCCradiofréquence(RF)dansleSupplémentCàOET65etRSS‐102delafréquenceradio(RF)ICrèglesd'exposition.Néanmoins,leproduitdoitêtreutiliséd'unemanièretellequelepotentielpourlecontacthumainpendantl'utilisationnormalesoitminimisé.Cetéquipementdoitêtreinstalléetutiliséàunedistanceminimumde20cmentreleradiateurettoutepersonneetnedoitpasêtreco‐implantéavecd'autresémetteurs,saufautorisationcontraire.Cedispositifestapprouvépourêtreutiliséavecuneantennedipôleavecungainmaximumde2dBi.Ceproduitintègreetestautoriséàêtreco‐localisésavecuneNovatelWirelessExpedite®E371PCIExpressMiniCard(FCCID:PKRNVWE371,IC:3229A‐E371).LeNovatelWirelessExpedite®E371PCIExpressMiniCardestaccordéeàunagrémentmodulairepourlesapplicationsmobiles.L'intégrationaétéfaitauxconditionssuivantes:1.Aumoins20cmdedistancedeséparationentrel'antenneettoutepersonnecorpsestmaintenueentouttemps.2.PourseconformeràlaFCC/ICrèglementsquilimitentàlafoislapuissancemaximaledesortieRFetl'expositionhumaineauxrayonnementsRF,legainmaximaldel'antenne,ycomprislapertedecâbledansuneconditiond'expositionseulementmobilenedépassepas3,5dBipour850MHzbandedefréquence,5,0dBipourdesfréquences700MHzbande,5,0dBipour1700MHzet3,0dBibandede1900MHzbandedefréquence.3.LeNovatelWirelessExpedite®E371PCIExpressMiniCardantennen'estpasco‐localiséavecd'autresantennes,saufavecl'antenneduproduitIPn4G.FCCClasseBpréavisappareilnumériqueCetéquipementaététestéetdéclaréconformeauxlimitesimposéesauxappareilsnumériquesdeclasseB,conformémentàlapartie15delaréglementationFCC.Ceslimitessontconçuespourfourniruneprotectionraisonnablecontrelesinterférencesnuisiblesdansuneinstallationrésidentielle.Cetéquipementgénère,utiliseetpeutémettreuneénergiedefréquenceradioet,s'iln'estpasinstalléetutiliséconformémentauxinstructions,ilpeutcauserdesinterférencesnuisiblesauxcommunicationsradio.Cependant,iln'existeaucunegarantiequedesinterférencesneseproduirontpasdansuneinstallationparticulière.Sicetéquipementprovoquedesinterférencesnuisiblesàlaréceptionradiooutélévision,cequipeutêtredéterminéenmettantl'équipementhorsetsoustension,l'utilisateurestencouragéàessayerdecorrigerl'interférenceparuneouplusieursdesmesuressuivantes:‐Réorienteroudéplacerl'antennederéception.‐Augmenterladistanceentrel'équipementetlerécepteur.‐Brancherl'équipementdansuneprisesuruncircuitdifférentdeceluisurlequellerécepteurestbranché.‐Consulterlerevendeurouuntechnicienradio/télévisionqualifiépourobtenirdel'aide.
© Microhard Systems Inc. 3 2.0 Quick Start This QUICK START guide will walk you through the setup and process required to access the WebUI configuration window and to establish a basic wireless connection to your carrier. Note that the units arrive from the factory with the Local Network setting configured as ‘Static’ (IP Address 192.168.168.1, Subnet Mask 255.255.255.0, and Gateway 192.168.168.1), in DHCP server mode. (This is for the LAN Ethernet Adapter on the back of the IPn4G unit. 2.1 Installing the SIM Card  Before the IPn4G can be used on a cellular network a valid SIM Card for your Wireless Carrier must be installed. Insert the SIM Card into the slot as shown below. 2.2 Getting Started with Cellular  Connect the power connector to the power adapter and apply power to the unit, the RF & SGNL LED’s will flash during boot-up, once they stop, proceed to the next step. SIM Card Slot To reset to factory defaults, press and hold the CFG button for 8 seconds with the IPn4G powered up. The LED’s will flash quickly and the IP4G will reboot with factory defaults. Use the MHS-supplied power adapter or an equivalent power source. The unit can also be powered via PoE using a MHS PoE injector. 9-30VDC
© Microhard Systems Inc. 4 2.0 Quick Start  Connect A PC configured for DHCP directly to the ETHERNET port of the IPn4G, using an Ethernet Cable. If the PC is configured for DHCP it will automatically acquire a IP Address from the IPn4G.  Open a Browser Window and enter the IP address 192.168.168.1 into the ad-dress bar.  The IPn4G will then ask for a Username and Password. Enter the factory defaults listed below. 192.168.168.1 The factory default network settings: IP: 192.168.168.1 Subnet: 255.255.255.0 Gateway: 192.168.168.1 The Factory default login: User name: admin Password: admin The factory default login: User name: admin Subnet: admin It is always a good idea to change the default admin login for future security.
© Microhard Systems Inc. 5  Once successfully logged in, the System Summary page will be displayed.  As seen above under Carrier Status, the SIM card is installed, but an APN has not been specified. Click on the Carrier > Settings tab and enter the APN sup-plied by your carrier in the APN field. Some carriers may also require a User-name and Password.  Once the APN and any other required information is entered to connect to your carrier, click on “Submit”. Return to the System > Summary tab. 2.0 Quick Start
© Microhard Systems Inc. 6  On the Carrier > Status Tab, verify that a WAN IP Address has been assigned by your carrier. It may take a few minutes, so try refreshing the page if the WAN IP Address doesn’t show up right away. The Activity Status should also show “Connected”.  To access devices connected to IPn4G remotely, one or more of the following must be configured: IP-Passthrough, Port Forwarding, DMZ. Another option would be to set up a VPN. 2.0 Quick Start
© Microhard Systems Inc. 7 150 Country Hills Landing NW Calgary, Alberta Canada T3K 5P3 Phone: (403) 248-0028 Fax: (403) 248-2762 www.microhardcorp.com

Navigation menu