META System S p A T2PLUS OBD device (On Board Diagnostic device) with Bluetooth 4.0 low energy User Manual 5040XXXXXX Ist Mon T 2 EN indd

META System S.p.A. OBD device (On Board Diagnostic device) with Bluetooth 4.0 low energy 5040XXXXXX Ist Mon T 2 EN indd

User Manual

T.2+ INSTALLATION MANUAL EN5040XXXXXXKIT COMPOSITIONINSTALLATIONPower Supply: ..................................................................................12Vdc (9V-14V)Working temperature: ..........................................................from -30°C to +80°CIP: .....................................................................................................................................40Application classi cation: ...........................................passenger compartmentTECHNICAL SPECIFICATIONSWARNINGS• ALL INSTALLATION OPERATIONS MUST BE CARRIED OUT WITH THE MOTOR OFF.• Before starting installation, detect the OBD port location referring to the use and maintenance manual of the vehicle.• If the OBD connector should be used for other purpose, such as maintenance, remove T2+ and, after tempo-rary operation, reconnect the T2+ to OBD connector. • Strictly comply with operations indicated in this manual.• Installation sta are not authorised to remove warranty seals and/or access the inside of the product.• The device must be connected to OBD port on board to the vehicle, provided with protected power supply by means a 5 A fuse maxiumum activation current.• The manufacturer assumes no responsibility for damages caused to property and/or people, caused by the incorrect installation of the product.TELEMATIC CONTROL UNIT12c2bOBD PORTBy using user manual of the vehicle  nd the OBD connector on your car.Typically OBD plug can be located:• near the breaks unit• near the fuse box• under the dashboard• in the middle consolePlug the connector into the vehi-cle’s OBD.Lock the Secondary Lock to se-cure the device.2aCheck that the device is fully connected and does not unlock.
Hereby, Meta System S.p.A., declares that this T.2+ is in compliance with the essential requirements and other relevant provisions of Directive R&TTE (1999/5).The declaration of conformity may be consulted at http://docs.metasystem.it APPROVALREMOVING THE PRODUCT3bThe instructions in this manual do not refer to speci c vehicle models but apply to all vehicles in general. Any information provided by Meta System regarding a type (model) of vehicle is to be considered purely indicative.Installation, positioning, product securing and electrical connections, and possibly the removal, must be carriedout in a workmanlike manner on each motor vehicle. The installer is obliged to and bears responsibility for ca-refully verifying the individual vehicle model on which operations are carried out. Failure to comply with that stipulated above can render the warranty of the device null and void.STANDARDS APPLICABLE TO THE VEHICLE3aUnlock the Secondary Lock to release the device. Remove the device.LEGENDA: Identi cation number of identify body.: Direct current of power supply.: Conformity mark to European certi cation.This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:1. This device may not cause harmful interference2. This device must accept any interference received, including interference that may cause undesired operation.Changes or modi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC APPROVAL

Navigation menu