Lutron Electronics 0077 Low Power Communication Device Transmitter User Manual 2

Lutron Electronics Company Inc Low Power Communication Device Transmitter 2

Contents

User Manual 2

LUTRON ELECTRONICS CO., INC. February, 2011 Page 1 of 1 Installation guide Applicable Model Numbers: X1019 Installation Instructions: The Clear Connect Module, model number X1019 with FCC ID JPZ0077, may only be installed into PSG thermostat, model number LUT-PFC-EO-2010-CPN5610. To install, place the Clear Connect Module on the 8 header pins on the backside of the PSG module with the antenna pointing to the top of the module. The entire enclosure must be mounted onto a metal back box to ensure FCC compliance. Please see Appendix A for the FCC statement for licensing information. Appendix A: FCC Information Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the seperation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Changes or modifications not expressly approved by Lutron Electronics Co. could void the user’s authority to operate this equipment. Operation is subject to the following: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu