Lexmark M01003 802.11 Wireless Adapter User Manual Date

Lexmark International Inc 802.11 Wireless Adapter Date

Contents

User manual information to user

Lexmark international, Inc.740 New Circle RoadC96L/005-1Lexington, KY 40550, USAPage 1 of 1June 23, 2009Product Labeling and User Guide Statements Checklist for New HostProducts Containing Certified Module LEX-M01-003Update Host Label with “Contains FCC ID: IYLM01003”Update Host Label with “Contains IC: 2376A-M01003”Update User Guide with “Contains certified module LEX-M01-003, FCC ID: IYLM01003 andIC: 2376A-M01003”Update Users Guide with “Federal Communications Commission (FCC)compliance information statement”. Full statement: “This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation. The FCC Class B limits are designed to provide reasonable protection against harmful interference when theequipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult your point of purchase or service representative for additional suggestions.The manufacturer is not responsible for radio or television interference caused by using other than recommendedcables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modificationscould void the user's authority to operate this equipment.”Also includes special note: “Note: To assure compliance with FCC regulations on electromagnetic interference for a Class Bcomputing device, use a properly shielded and grounded cable such as Lexmark part number 1021294 for USB attach. Useof a substitute cable not properly shielded and grounded may result in a violation of FCC regulations.”Update Users Guide with “Industry Canada compliance statement: This Class B digital apparatus meets allrequirements of the Canadian Interference-Causing Equipment Standard ICES-003.” (In both English and French)Update User Guide with “Exposure to radio frequency radiation: The radiated output power of this device is farbelow the radio frequency exposure limits of the FCC and other regulatory agencies. A minimum separation of 20cm (8 inches) must be maintained between the antenna and any persons for this device to satisfy the RF exposurerequirements of the FCC and other regulatory agencies.”Update User Guide with “Industry Canada (Canada): This device complies with Industry Canada specification RSS-210. Operation is subject to the following two conditions:(1) this device may not cause interference, and (2) this device must accept any interference, including interferencethat may cause undesired operation of the device.This device has been designed to operate only with the antenna provided. Use of any other antenna is strictlyprohibited per regulations of Industry Canada.To prevent radio interference to the licensed service, this device is intended to be operated indoors and away fromwindows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject tolicensing.The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emitRF fields in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from HealthCanada's Web site www.hc-sc.gc.ca/rpb.The term "IC:" before the certification/registration number only signifies that the Industry Canada technicalspecifications were met. “ (In English and French)Mike KlaveRegulatory Engineer Lexmark International740 New Circle RdBldg 005/1 C96L Lexington, KY 40550Tel: +1 (859) 232-3512E Mail: klavem@lexmark.com

Navigation menu