Le Shi Zhi Xin Electronic Technology LEUBP-201E Letv Selfie Stick User Manual

Le Shi Zhi Xin Electronic Technology (Tian jin) Limited Letv Selfie Stick

User manual

How to connect via BluetoothProductWeight: 173g Extended length: 66cm Materials: aluminum, plascPacking dimensions: 213x61x41mmBaeryCapacity: 65mAh Standby me: 3 daysWorking me: 30H Charging voltage: 5VInput current: 300MA-2A Charging me: 1.5HCharge cycles: ≥ 300In the Box: selfie sck x1 lanyard x1 user manual x1 3R warranty cerficate x1 data cable x1 85mm45mmKind noce: If the Letv selfie sck is not connected to a phone 10 minutes aer it is powered on, the indicator will go off and the selfie sck will go into the hibernaon mode. In the photo-taking mode, the indicator will go off and the selfie sck will go into the hibernaon mode if idle for 24 hours. If the connected phone goes out of range (10m in tesng environment), the selfie sck will go into the hibernaon mode. You can wake it up by pressing the selfie buon.Step 1.Press the buon for 3 seconds and the LED indicator will glow blue, indicang that the selfie sck is powered on. When the indicator flashes blue, the device is in the Bluetooth pairing mode (if it has never been connected) Reconnecng mode (auto connecng to a paired device in 5 seconds)Step 2.Turn on Bluetooth on the phone, search for “letv-ZPG”, and tap it to auto pair and connect. When connected, the indicator on the selfie sck will glow blue, and the photo-taking mode is ready to useStep 3.Place the phone into the bracket, launch Camera on the phone, and press the selfie buon to take photos/record videosNotes1. Store and use the product in normal temperature. 2. Do not expose this product to rain and water or use in a wet environment.3. Do not throw the product to avoid damage.4. Do not use chemical solvents to coat or wipe the product.5. The maximum weight capacity of the phone bracket and connecng rod is 1kg.6. Do not use the selfie sck where you are not prohibited.7. Check it in as luggage when taking a flight.How to use the Letv selfie sckBluetooth connecon*Press for 3 second to power onPress for 3 second to power off456Press the selfie buon to take photos/record videosWe suggest you to remove the phone case when using this device. Do not twist the selfie sck using extra force.(The indicator glows red during charging and goes off when fully charged)(The indicator glows blue when powered on and flashes blue when pairing)LeUBP-201EThe statements should be displayed in the user manual:changes or modifications not expressly approved by the party responsible for compliance could void the user’s aut-hority to operate the equipment. This device complies with Part 15 of the FCC Rules. Oper-ation is subject to the following two conditions: (1) this dev-ice may not cause harmful interference, and (2) this device must accept any interference received, including interferen-ce that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide re-asonable protection against harmful interference in a resid-ential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and use-d in accordance with the instructions, may cause harmful i-nterference to radio communications. However, there is no guarantee that interference will not occur in a particular ins-tallation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following m-easures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu