Landis Gyr Technology IWRS5 Gridstream Series-5 IWR User Manual 12 0336 Exhibit Cover

Landis+Gyr Technology, Inc. Gridstream Series-5 IWR 12 0336 Exhibit Cover

Manual

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598Certification ExhibitFCC ID: R7PIWRS5IC: 5294A-IWRS5FCC Rule Part: 15.247IC Radio Standards Specification: RSS-210ACS Project Number: 12-0336Manufacturer: Landis+Gyr Technology, Inc.Model: Gridstream Series-5 IWRManual
LANDIS+GYR CONFIDENTIAL INFORMATIONLandis+GyrGridstream Series-5 IWRData SheetPublication: 98-1297 Rev AADRAFT 01/10/2013
Limitation on Warranties and LiabilityInformation in this document is subject to change without notice. This manual or any part of it thereof may not be re-produced in any form unless permitted by contract or by written permission of Landis+Gyr.In no event will Landis+Gyr be liable for any incidental, indirect, special, or consequential damages (including lost prof-its) arising out of or relating to this publication or the information contained in it, even if Landis+Gyr has been advised, knew, or should have known of the possibility of such damages.© 201# Landis+Gyr, Inc. All Rights ReservedLandis+Gyr Gridstream Series-5 IWR Data SheetPublication: 98-1297 Rev AARevision HistoryModification Date Revision Description Author01/10/2013 AA Work in progress Kim UteschLandis+Gyr6436 County Road 11Pequot Lakes, MN 56472Website: www.landisgyr.comE-mail: solutionsupport.na@landisgyr.comTechnical Support: 1-888-390-5733© 2013 Landis+GyrAll rights reserved.DRAFT 01/10/2013
Data Sheet 98-1297 Rev AA 3Landis+GyrGridstream Series-5 IWR Data SheetGeneralThe Landis+Gyr Gridstream Series-5 IWR provides a basis for a powerful RF wireless mesh network for remote data collection and end device monitoring and control. The radio provides full two-way peer-to-peer communication to all devices within the network. The IWR also offers advanced func-tionality, such as individual message prioritization, additional memory for localized intelligence, and a programming language Device Control Word (DCW) used to provide interface and control to dis-tributed automation equipment. The IWR has one RS-232 serial port for the LAN Packet Port (LPP) and one RS-232/485 serial port for the Transparent Packet Port (TPP). The LAN Packet Protocol Port is used to communicate to de-vices that use the Gridstream IWR LAN Packet Protocol, such as a PC with configuration or diagnos-tic software. The Transparent Packet Port is a general-purpose data port that is used to transport byte-oriented data, such as DNP 3.0, Modbus, or DF1.Figure 1. Landis+Gyr Gridstream Series-5 IWRDRAFT 01/10/2013
Landis+Gyr Gridstream Series-5 IWR Data Sheet Landis+Gyr4 98-1297 Rev AA Data SheetIWR UsageThe IWR was engineered specifically for varied needs of residential and commercial applications. It enables access to the RF mesh network using a standard RS-232 connection.Useful features of the IWR include:•User-friendly interface via RadioShop for configuring the IWR. The interface provides:•Current status information•Logical configurations for:•LPP port•TPP port•Simultaneous connections per RS-232 interface by:•LPP applications•TPP applicationsFCC and Industry Canada ComplianceFCC Class BThis device complies with Part 15 of the FCC rules. Operation is subject to the following two condi-tions: 1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pur-suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the Instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television re-ception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna. •Increase the separation between the equipment and receiver. •Consult Landis+Gyr or an experienced radio technician for helpUWARNING: Changes or modifications to this device not expressly approved by Landis+Gyr could void the user’s authority to operate the equipment.DRAFT 01/10/2013
Landis+Gyr Landis+Gyr Gridstream Series-5 IWR Data SheetData Sheet 98-1297 Rev AA 5RF ExposureThis equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 22 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Industry CanadaThis device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.This radio transmitter (5294A-IWRS5) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.Approved Antenna: Omni-directional antenna, 5.5 dBi gain, 902-928 MHz, antenna impedance is 50 ohms.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utili-sateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équiv-alente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.Le présent émetteur radio (5294A-IWRS5) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.Host FCC Label RequirementIn the final installation, the following information must be visible:•Contains FCC ID: R7PIWRS5•Contains IC: 5294A-IWRS5•Module Model: Gridstream Series-5 IWRDRAFT 01/10/2013
Landis+Gyr Gridstream Series-5 IWR Data Sheet Landis+Gyr6 98-1297 Rev AA Data SheetThis device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesired operation.Gridstream Series-5 IWR SpecificationsTable 1. General Series-5 IWR SpecificationsElectrical (General)Input Voltage Range 6 - 28 VDCInput Current (in transmitting mode) 320 mA typical (12 VDC operation)Input Current (in receiving mode) 38 mA typical (12 VDC operation)RF Frequency Range 902-928 MHzChannel Spacing 100 or 300 kHz depending on the modeRF Data Rate 9.6-115.2 KbpsReceiverSensitivity (at 10% packet error rate) -112 dBm (9.6 Kbps) Typical / -101 dBm (115.2 Kbps) TypicalCo-channel rejection 10 dB TypicalAdjacent Channel Rejection 30 dB TypicalAlternate Channel Rejection 45 dB TypicalTransmitterOutput Power (at Antenna Connector) 21/25/30 dBm (user selectable)Modulation Type 2-FSK, GFSKModulation Index 1Out-of-band Spurious Emissions <-70 dBcDRAFT 01/10/2013

Navigation menu