Kohler KOHLER001 Remote Control Transmitter User Manual 1021550 5 a

Kohler Co. Remote Control Transmitter 1021550 5 a

Users Manual

1021550-5-ABath WhirlpoolRemote ControlHomeowners GuideK-1703
1021550-5-A2Kohler Co.HeaterOn/Off IncreasesFlowDecreasesFlowPowerOn/OffRemote ControlThe remote control places the whirlpool functions at your fingertipsto further enhance your bathing experience. The functions of theremote are identical to the user keypad. You may turn the whirlpoolon and off, turn the heater on and off, and increase or decrease thewater flow by the press of a button.The waterproof remote control is designed to be used in the bath andwill float in the water.Two AAA batteries are used in the remote control. To replace, simplyunscrew the end cap and insert the batteries, as shown above.Tighten the end cap securely, making sure the end cap makes contactwith the seal.
1021550-5-A3Kohler Co.FCC ComplianceFCC ID : N82-KOHLER001Canada ID : 4554A-KOHLER001Compliance Statement (Part 15.19)This device complies with Part 15 of the FCC Rules and withRSS-210 of Industry Canada. Operation is subject to the followingtwo conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, includinginterference that may cause undesired operation.Warning (Part 15.21)Changes or modifications not expressly approved by the partyresponsible for compliance could void the users authority to operatethe equipment.Programming Your Remote ControlNOTE: Programming of the remote control is normally not required.If more than one device in your home, or in the near vicinity of yourhome, uses a remote control, it may be necessary to program thisremote control to the user keypad. If you replace your remotecontrol, or replace the pump control, it may be necessary to programthe remote control.-Turn power on to the whirlpool.-Turn off all modes of operation. Wait approximately one minuteuntil the keypad darkens (sleep mode).-On the user keypad, press the up arrow, down arrow and the heaterbutton simultaneously. The bottom LED, on the keypad’s indicatorbar, will begin flashing.-While the LED is flashing, press the heater button on the keypad. Alight sequence will illuminate up and down the indicator bar.-While the indicator bar light sequence is active, press any button onthe remote control. The program will download and the user keypadwill darken. The user keypad will now respond only to this remotecontrol.
1021550-5-A4Kohler Co.Homeowners GuideBath Whirlpool Remote ControlE2003 Kohler Co.1021550-5-AUSA: 1-800-4-KOHLERCanada: 1-800-964-5590Mexico: 001-877-680-1310kohler.com

Navigation menu