Kapsch Trafficcom 9734 IEEE 802.11p communication module User Manual

Kapsch Trafficcom AG IEEE 802.11p communication module

User Manual

Kapsch TrafficCom AG User Manual OMR WAVE-UNIT This device is based on the IEEE WAVE Standards 1000005542-Bed-02
1000005542-Bed-02 Document number 1000005542 Document type Bed Document version 02 Document status released Date of release 2010-04-21 Valid from Software version - Created by: Batko Manfred Checked by: Povolny Robert Approved by: Komarica Anto Disclaimer and Limitation of Liability The products described in this manual are provided “as is” and without any warranties of any kind, either express or implied. Kapsch TrafficCom disclaims all warranties, express or implied, including, but not limited to, warranties of title, legality or non-infringement or misappropriation of any intellectual property rights of third parties or implied warranties of merchantability or fitness for a particular purpose. Under no circumstances will Kapsch TrafficCom (including its affiliates, licensors, contractors, suppliers, assignees, subsidiaries, and the respective officers, directors, employees, shareholders, agents and representatives of each of them) be liable for any expenses, fees, claims, damages or losses in any way relating to or arising out of the products described in this manual. Applicable law may not allow certain warranty exclusions, so one or more of the above disclaimers may not apply to you. Copyright  Kapsch TrafficCom AG 2010 Duplication as well as utilization of contents of this documentation are illegal without our explicit consent.
User Manual | OMR-WAVE-UNIT Page 3 of 15 1000005542-Bed-02 Table of Contents Page Information about this document 5 Text conventions ............................................................................................. 5 Important text elements ................................................................................... 5 Abbreviations ................................................................................................... 6 Warning to users in the United States 7 Regulatory Information 8 Software Licenses 9 Safety Instructions 9 Environmental Information 9 Visual Inspection 9 Maintenance Instructions 9 General Information 10 Definitions ...................................................................................................... 10 Ordering Information 10 Installation 11 Reading OBUs 12 Product Specifications 13 Conformity 14 Standards ...................................................................................................... 14 List of tables Table 1 Abbreviations and definitions ............................................................. 6 Table 2 Article numbers for accessories ....................................................... 10 Table 3 Standards ......................................................................................... 14
User Manual | OMR-WAVE-UNIT Page 5 of 15 1000005542-Bed-02 Information about this document This document is for professionals setting up and maintaining the equipment. Professionals are persons, who have basic knowledge of software installation and computer equipment. This User Manual shall be carefully read before installation. Text conventions Visual aids and standard text formats in this manual help the reader to locate and identify information easily. Typographical formats: Style Used for bold Accentuations italics Labelling and cross-references CAPITAL LETTERS Acronyms Note: Contains additional information on the topic. Important text elements This manual contains specific Caution and Warning statements. These shall be interpreted as follows: Attention: This warning indicates that the device may be affected by Electrostatic Discharge. Appropriate precautions must be made to avoid damage to the device. Caution: Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. Warning: Indicates a hazardous situation which, if not avoided, could result in death or serious injury. Audience Preparations Table 1 Text formats and their meaning Attention Caution Warning
Page 6 of 15 User Manual | OMR WAVE-UNIT 1000005542-Bed-02 Abbreviations DSRC Dedicated Short Range Communication OBU Onboard Unit (adjustable by user) RF Radio Frequency WAVE Wireless Access in Vehicular Environments Table 1 Abbreviations and definitions
Warning to users in the United States Page 7 of 15 1000005542-Bed-02 Warning to users in the United States The hardware referred to in this document allows selection of frequency bands and transmit power levels that may not comply with the regulatory body that governs spectrum policy where the hardware is being used. This equipment is certified under 47 CFR Part 90M as a portable RSU. However, portable or hand-held RSUs are permitted to operate where they do not interfere with a site-licensed operation. There might be also local restrictions referred in 47 CFR Part §90.371, 47 CFR Part §90.383, 47 CFR Part §90.375. Local Regulations Local Restrictions
Page 8 of 15 User Manual | OMR WAVE-UNIT 1000005542-Bed-02 Regulatory Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made to this equipment not expressly approved by Kapsch may void the FCC authorization to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm (8 inches) between the radiator and a human body. Failure to do so could result in bodily injury or death. This transmitter must not be co-located or operate in conjunction with any other antenna or transmitter. Notice Notice Class B digital device Radio frequency radiation exposure Information
Software Licenses Page 9 of 15 1000005542-Bed-02 Software Licenses This product may contain software portions including technologies used under third party license, and are copyrighted. Notices, Terms and Conditions pertaining to third party software are located at http://www.kapsch.net/us/en/ktc/portfolio/products_and_components/Pages/default.aspx Safety Instructions Caution: During operation the WAVE-UNIT must not be held closer than 20cm (8 in) to the body and must not point to the body of another person. Environmental Information The equipment consists of material that can be recycled. Please follow the local regulations regarding the disposal of packaging material and waste electronic equipment. This device is designed for outdoor and indoor use. Visual Inspection After unpacking please check the equipment for possible damages. If the content is incomplete or damaged please contact your local Kapsch office. Maintenance Instructions Caution: Regular inspection of the equipment is mandatory and shall be in accordance with local safety regulations. Check for damage before using the equipment. Recycling Environmental requirements
Page 10 of 15 User Manual | OMR WAVE-UNIT 1000005542-Bed-02 General Information Definitions The PDA is a handheld unit, which shall be used with the OMR-WAVE-UNIT. It has to be compatible with the GOTIVE H42 device. The OMR-WAVE-UNIT is a module for the GOTIVE H42 and compatible devices, which is compliant to the WAVE standard. The reader consists of a PDA device and an OMR-WAVE-UNIT The reading range is defined as the maximum distance from the reader to the OBU, in which reliable WAVE communication is possible. Ordering Information Kapsch article number Description 34018470010 GOTIVE H42 4027070000 OMR-9734 (GOTIVE H42 + OMR-WAVE-UNIT) PDA WAVE UNIT Reader Reading Range Table 2 Article numbers for accessories
Installation Page 11 of 15 1000005542-Bed-02 Installation Adjust the lug of WAVE-UNIT in the appropriate slot the PDA and press the WAVE module down until it locks with the PDA. Check for correct fit. Press the button on the WAVE-UNIT and pull the WAVE-UNIT off. The PDA can be charged without removing the WAVE-UNIT module. Plug in cable in jack on the side of the WAVE-UNIT. Warning: The WAVE-UNIT does not include any charging control mechanisms for the PDA. To prevent damage to the device or injury to humans contact the PDA manufacture for detailed instructions about charging. Mount the WAVE unit Remove the WAVE unit Charging
Page 12 of 15 User Manual | OMR WAVE-UNIT 1000005542-Bed-02 Reading OBUs Reading Range up to 10feet (3m) The typical reading range is up to 3m (10feet) and depends on these parameters:  OBU’s mounting angle on windshields  Offset angle to bore sight between reader unit and OBU Note: When reading a specific OBU make sure that no other OBU’s are in the communication range of the reader to prevent reading the wrong OBU. To reduce the risk of reading wrong OBUs choose the distance between the reader and the OBU as close as possible, but not closer than 0.5m(20in).
Product Specifications Page 13 of 15 1000005542-Bed-02 Product Specifications 4in x 3in x 1.5in 108mmx 68mm x 37mm [LxWxH] USB powered device Power consumption (operating mode) max. 2.5W Temperature (operation) -10°C … +55°C 14°F … +131°F Storage temperature -30°C … +60°C -22°F … +140°F Ambient humidity 5 to 95% non condensing USB 2.0 full speed USB powered device Frequency range 5.850GHz - 5.925GHz Channels 172,174,176,178,180,182,184 Data Rates 3MBit/s – 27MBit/s 47 CFR Part 90 M 47 CFR Part 15 B UL-60950-1, 2nd edition UL-60950-22, 2nd edition CSA C22.2 No. 60950-1-07, 2nd edition UL: E323290 Mechanical data Electrical data Environmental conditions Interface RF Interfaces Compliance
Page 14 of 15 User Manual | OMR WAVE-UNIT 1000005542-Bed-02 Conformity Standards Ref. Standard Description [1] ASTM E2213 - 03 Standard Specification for Telecommunications and Information Exchange Between Roadside and Vehicle Systems — 5 GHz Band Dedicated Short Range Communications (DSRC) Medium Access Control (MAC) and Physical Layer (PHY) Specifications [2] IEEE 802.11™a-2007 IEEE Standard for Information technology— Telecommunications and information exchange between systems— Local and metropolitan area networks— Specific requirements Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications [3] IEEE 802.11™p IEEE Standard for Information technology— Telecommunications and information exchange between systems— Local and metropolitan area networks— Specific requirements Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications Amendment 7: Wireless Access in Vehicular Environments [4] IEEE 1609.4™ Draft Standard for Wireless Access in Vehicular Environments (WAVE) - Multi-channel Operation [5] IEEE 1609.3™ Draft Standard for Wireless Access in Vehicular Environments (WAVE) – Networking Services Table 3 Standards
Conformity Page 15 of 15 1000005542-Bed-02 For further information please contact: Kapsch TrafficCom U.S. Corp. 21515 Ridgetop Circle, Suite 290 Sterling, VA 20166 Phone: +1 (703) 885 1976 Kapsch TrafficCom AG Am Europlatz 2 A-1120 Vienna Phone: +43 (0)50 811 0 Fax: +43 (0)50 811 2589 E-mail: kapsch.at@kapsch.net Address

Navigation menu