KYE SYSTEMS GMZKZ 2.4GHz Wireless Mouse User Manual Hardware Installation

KYE Systems Corp 2.4GHz Wireless Mouse Hardware Installation

FSUGMZKZ User Manual

English 1 Getting Started: 1. Before you can use this device, it needs to be charged, so connect the micro USB cable to Micro Traveler 9000R and any USB port on your PC. It takes approximately two until three hours to fully charge. 2. In charging mode, the LED light will be on and will turn off when charged. 3. Connect the USB receiver to any USB port on your PC. 4. Make sure that you have switched on the power switch underneath the mouse. Note: If the LED is flashing, you need to recharge the mouse immediately. Mouse Button Assignments 1. Left Button: Provides traditional mouse functions like click, double click and drag. 2. Magic-Roller: Press the “Magic-Roller” to surf the Internet and Windows documents. 3. Right Button: Provides traditional mouse click functions. 4. LED indicator: Indicates device Starting/Charging/Battery low - Starting: LED lights up for three seconds to initiate. - Charging: LED light is ON. - Fully charged: LED light is OFF. - Battery low: LED will flash at a slow speed to indicate low battery power. Note: Download the programmable driver from our website: www.geniusnet.com Warning: (Troubleshooting) 1. Do not use the wireless optical/laser mouse on a desk which is made of glass or mirror. 2. The connection of the wireless device is factory preset, so when you plug the USB receiver into any USB port, the connection between the micro receiver and the mouse will be established automatically. 3. In case your PC did not install the hardware successfully, remove the micro receiver from the USB port and go Human Interface Devices under Device Manager to remove the mouse then plug in the micro receiver to a USB port again. 4. If you feel the mouse does not move smooth as usual, you need to recharge the mouse immediately.
English 2 Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. (15.21) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.(15.19(a)(3)) FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Navigation menu