KYE SYSTEMS GG000V HS-930BT User Manual

KYE Systems Corp HS-930BT Users Manual

User Manual

English1. General Functions 2. Pairing to a phone or entertainment device:  TurnonyourphoneandensureitsBluetoothfunctionisactivated.　 TurnontheBluetoothHeadsetandgototheparingmode. SearchyourBluetoothdevicesonyourphonebyfollowingthephone'sinstructions.Refertoyourphone'susermanualformoreinformation.　 Afterafewsecondthephonewilllistthedeviceasadiscoverdevice. Selectitandfollowyourphoneinstructiontoselectthispairing.　 Yourphonewillconfirmthepairing,andthenpressYes/Ok 　 Finally,select“connectwithdevice”fromyourphone.3. Line in input HS‐930BTsupportsa3.5mmaudiojacklineinwhenthebatteryisloworwherewirelessdevicescannotbeused.FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Declaration of Conformity(R&TTE 1999/5/EC) Hereby, KYE SYSTEMS CORP.,Ltd declares that this Bluetooth Speaker product is in compliance with essential requirements and other relevant provisions of Directive 1999/5/EC.A copy of the Declaration of conformity can be found at http://www.geniusnet.com  FCC RF Radiation Exposure Statement: 1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device was tested for typical hand held operations with the device contacted directly to the human body to the sides of the device. To maintain compliance with FCC RF exposure compliance requirements, avoid direct contact to the transmitting antenna during transmitting Turnon Presspowerbuttonuntilthelightturnsblue,ifthereisadeviceconnectedbefore,automaticallyconnectthepreviousdevice,otherwiseenterpairingmode,theredandblueflashinturns. EnterthepairingmodeIfproductispairedbefore,itwillautomaticallyconnectthepreviousdevicewhenturnedon.Ifthere’snopreviousdevice,itwillenterpairingmode,theredandblueflashinturns,whenconnected,andtheblueLEDflashesbluetwiceper5seconds.PairingInpairingmode,useamobilephonewithBluetoothfunctionorotherBluetoothMasterDevicetoperformpairingaction.TurnoffWhendeviceison,pressthepowerbutton4seconds,theredLEDflashesfor1second,theproductshutsdown.ChargingPlugthechargertoportofthedevice.(RedLEDison.)AnswercallShortpresspowerbuttonforanincomingcall.EndcallShortpresspowerbuttonagaintoendcall.TransfercallbetweenheadsetanddeviceLongpresspowerbuttonfor1secondtotransferthecallbetweenthemobilephoneandthedeviceduringon‐goingcall.RejectcallLongpresspowerbuttonfor1~2secondstorejectincomingcall.IncomingsecondcallWhenthere’sasecondincomingcall,shortpressthepowerbuttontoanswerthesecondcallorlongpressthepowerbuttonfor1secondtorejectthesecondcall.Whenansweringthesecondcall,thecurrentcallwillbeonhold.Longpressthemiddlebuttonfor1secondtoswitchbetweenthesecondcallandthepreviouscall,shortpressthemiddlebuttontoendthecurrentcall.VolumeupShortPress“+”buttonforvolumeup.VolumeDownShortPress“‐”buttonforvolumedownNextShortpress“V”buttonfornexttrack.PreviousShortpress“Λ”buttonforprevioustrack.Play/pauseShortpresspowerbuttontoplay/pausethemusicwhentheproductisconnected.StandbyUnderpairingmode,ifthereisnodevicetoconnect,itgoesintostandbymode.Automaticpower‐offInstandbymode,ifthereisnodevicetoconnect,itwillshutdownautomaticallyin2minutes.FactoryresetPress“+”and“‐”for4seconds,lightflashesredonce,torestorefactorysettings.Pairinginformationiscleared,youwillneedtoenterpairingmodeagaintoactivatetheBluetoothfeature.

Navigation menu