Japan Radio NJJ-200 Handy Search User Manual Instruction of testing sample
Japan Radio Co Ltd. Handy Search Instruction of testing sample
Contents
- 1. Users Manual 1
- 2. Users Manual 2
- 3. Users Manual 3
- 4. Instruction of testing sample
Instruction of testing sample
![HX0BD14031(1/1) 6.24.2014 Japan Radio Co., Symptom: Sensor ID does not show up in the sensor select screen of [Sensor select] menu The symptom happens when wireless LAN is not established between Smartphone and the sensor unit. The three possible causes and solutions are listed below. Cause 1: The sensor select screen was selected before establishing wireless LAN communication after turning on. Solution: Wait two or three minutes and see if the sensor ID appears in the sensor select screen. Cause 2: The sensor unit is turned off. Solution: Confirm that the sensor unit’s Power LED turns on in red. If the Power LED turned off, check if the charged battery pack is installed and the sensor unit is switched to N position. in 3 m near by the sensor unit, then check if the sensor ID appears in ensor select screen. tphone and the sensor unit. And please send back Smartphone and e sensor unit to us. O Cause 3: The distance between Smartphone and the sensor unit exceeds 3 m. Solution: Confirm that the distance does not exceed 3 m. If the distance exceeded 3 m, move Smartphone withs If any solutions above did not solve the symptom, it may be caused by the failure of Smartphone or the sensor unit. In this case, please let us know the status, then we will send the substitute of Smarth](https://usermanual.wiki/Japan-Radio/NJJ-200.Instruction-of-testing-sample/User-Guide-2304310-Page-1.png)