Jada Toys JT49TX91000 9” Chub City RC and 4.5” Chub City RC. User Manual 83047 IS US01 Front

Jada Toys Company Limited 9” Chub City RC and 4.5” Chub City RC. 83047 IS US01 Front

Contents

user man pt 1

TROUBLE SHOOTINGPROBLEM SOLUTIONCar will not STARTCar does not respondto controls.Car does not drive straight.1. Power switch is off. Turn on. 2. Batteries are installed withincorrect polarities. Check the + and - markings to make sure thebatteries are properly aligned. 3. Batteries are drained. Chargebatteries and/or install new batteries.1. Transmitter controller battery is drained. Replace the 9Vcontroller battery. 2. Vehicle is out of range. Bring controllercloser to the vehicle. 3. Interference from surrounding electricalmachinary. Bring to a wide open space.1. Adjust the steering dial underneath the front axle, left or right,until the wheels point straight forward.COMPLIANCE WITH FCC REGULATIONS (VALID IN U.S. ONLY) THIS DEVICE COMPLIES WITH PART 15 FCC RULES. OPERATION OF THIS DEVICE IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.2. THIS DEVICE MUST ACCEPT ANY HARMFUL INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.This device generates and uses radio frequency energy and if not used properly may cause interference to radio and television reception. It has been tested and found to comply with the limits set by the FCC which are designed to provide reasonable protection against such interference.FCC Warning:CAUTION:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:--Reorient or relocate the receiving antenna.--Increase the separation between the equipment and receiver.--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.--Consult the dealer or an experienced radio/TV technician for help.

Navigation menu