JVC KENWOOD 479000 VHF DIGITAL TRANSCEIVER User Manual 2 of 2

JVC KENWOOD Corporation VHF DIGITAL TRANSCEIVER Users Manual 2 of 2

Contents

Users Manual - 2 of 2

Radio FRequency eneRgy SaFety inFoRmationThis KENWOOD transceiver has been tested and complies with the standards listed below, in regards to Radio Frequency (RF) energy and electromagnetic energy (EME) generated by the transceiver.• FCC RF exposure limits for Occupational Use Only. RF Exposure limits adopted by the FCC are generally based on recommendations from the National Council on Radiation Protection and Measurements, & the American National Standards Institute.• FCCOETBulletin65Edition97-01SupplementC• AmericanNationalStandardsInstitute(C95.1–1992)• AmericanNationalStandardsInstitute(C95.3–1992)This KENWOOD transceiver generates RF EME while transmitting. RF EME (Radio Frequency Electric &MagneticEnergy)hasthepotentialtocauseslightthermal,orheatingeectstoanypartofyourbodyless than the recommended distance from this radio transmitter’s antenna. RF energy exposure is determined primarily by the distance to and the power of the transmitting device. In general, RF exposure is minimized when the lowest possible power is used or transmission time is kept to the minimum required for consistent communications, and the greatest distance possible from the antenna to the bodyismaintained.ThetransceiverhasbeendesignedforandisclassiedforOccupational Use Only. Occupational/ controlled exposure limits are applicable to situations in which persons are exposed to RF energy as a consequence of their employment, and such persons have been made aware of the potential for exposure and can exercise control over their exposure. This means you can use the transceiver only if you are aware of the potential hazards of operating a transceiver and are familiar in ways to minimize these hazards. This transceiver is not intended for use by the general public in uncontrolled environments. Uncontrolled environment exposure limits are applicable to situations in which the general public may be exposed to RF energy, or in which the persons who are exposed as a consequence of their employment may not be fully aware of the potential for exposure or cannot exercise control over their exposure.The following list provides you with the information required to ensure that you are aware of RF exposure and of how to operate this transceiver so that the FCC RF exposure limitations are not exceeded.• Whiletransmitting(holdingthePTTswitchorspeakingwithVOXenabled),alwayskeeptheantennaandtheradioatleast3cm(13/16inches)fromyourbodyorface,aswellasfromanybystanders. A LED on the top of the radio shows red when the transmitter is operating in both PTTandVOXmodes.• Donottransmitformorethan50%ofthetotaltransceiverusetime;transmittingover50%ofthetotal use time may exceed the limits in accordance to the FCC RF exposure requirements. Nominal transceiveroperationis5%transmissiontime,5%receptiontime,and90%stand-bytime.• Useonlythespeciedantennaforthistransceiver;thismaybeeithertheantennaprovidedwiththe transceiver or another antenna authorized by KENWOOD.Use only KENWOOD authorized accessories (antennas, battery packs, belt clips, Speaker/ Mics or headsetsetc.):Whenwornonthebody,alwaysplacetheradioinaKENWOOD recommended clip orcarryingcasemeantforthisproduct.Theuseofotherthanrecommendedorapprovedbody-wornaccessories may result in RF exposure levels which exceed the FCC’s occupational/ controlled environment RF exposure limits.To ensure that your exposure to RF EME is within the FCC limits for occupational use, you must observe and adhere to the above points.Electromagnetic Interference CompatibilityElectronic devices are susceptible to electromagnetic interference (EMI) if they are not adequately shieldedordesignedforelectromagneticcompatibility.BecausethistransceivergeneratesRFenergy,itcan cause interference to such equipment.• TurnOFFyourtransceiverwheresignsarepostedtodoso.Hospitalsandhealthcarefacilitiesuseequipment that is sensitive to electromagnetic radiation.• TurnOFFyourtransceiverwhileonboardanaircraftwhensoinstructed.Useofthetransceivermust be in accordance with airline regulations and/or crew instructions.

Users Manual_2 of 2

Radio FRequency eneRgy SaFety inFoRmationThis KENWOOD transceiver has been tested and complies with the standards listed below, in regards to Radio Frequency (RF) energy and electromagnetic energy (EME) generated by the transceiver.• FCC RF exposure limits for Occupational Use Only. RF Exposure limits adopted by the FCC are generally based on recommendations from the National Council on Radiation Protection and Measurements, & the American National Standards Institute.• FCCOETBulletin65Edition97-01SupplementC• AmericanNationalStandardsInstitute(C95.1–1992)• AmericanNationalStandardsInstitute(C95.3–1992)This KENWOOD transceiver generates RF EME while transmitting. RF EME (Radio Frequency Electric &MagneticEnergy)hasthepotentialtocauseslightthermal,orheatingeectstoanypartofyourbodyless than the recommended distance from this radio transmitter’s antenna. RF energy exposure is determined primarily by the distance to and the power of the transmitting device. In general, RF exposure is minimized when the lowest possible power is used or transmission time is kept to the minimum required for consistent communications, and the greatest distance possible from the antenna to the bodyismaintained.ThetransceiverhasbeendesignedforandisclassiedforOccupational Use Only. Occupational/ controlled exposure limits are applicable to situations in which persons are exposed to RF energy as a consequence of their employment, and such persons have been made aware of the potential for exposure and can exercise control over their exposure. This means you can use the transceiver only if you are aware of the potential hazards of operating a transceiver and are familiar in ways to minimize these hazards. This transceiver is not intended for use by the general public in uncontrolled environments. Uncontrolled environment exposure limits are applicable to situations in which the general public may be exposed to RF energy, or in which the persons who are exposed as a consequence of their employment may not be fully aware of the potential for exposure or cannot exercise control over their exposure.The following list provides you with the information required to ensure that you are aware of RF exposure and of how to operate this transceiver so that the FCC RF exposure limitations are not exceeded.• Whiletransmitting(holdingthePTTswitchorspeakingwithVOXenabled),alwayskeeptheantennaandtheradioatleast3cm(13/16inches)fromyourbodyorface,aswellasfromanybystanders. A LED on the top of the radio shows red when the transmitter is operating in both PTTandVOXmodes.• Donottransmitformorethan50%ofthetotaltransceiverusetime;transmittingover50%ofthetotal use time may exceed the limits in accordance to the FCC RF exposure requirements. Nominal transceiveroperationis5%transmissiontime,5%receptiontime,and90%stand-bytime.• Useonlythespeciedantennaforthistransceiver;thismaybeeithertheantennaprovidedwiththe transceiver or another antenna authorized by KENWOOD.Use only KENWOOD authorized accessories (antennas, battery packs, belt clips, Speaker/ Mics or headsetsetc.):Whenwornonthebody,alwaysplacetheradioinaKENWOOD recommended clip orcarryingcasemeantforthisproduct.Theuseofotherthanrecommendedorapprovedbody-wornaccessories may result in RF exposure levels which exceed the FCC’s occupational/ controlled environment RF exposure limits.To ensure that your exposure to RF EME is within the FCC limits for occupational use, you must observe and adhere to the above points.Electromagnetic Interference CompatibilityElectronic devices are susceptible to electromagnetic interference (EMI) if they are not adequately shieldedordesignedforelectromagneticcompatibility.BecausethistransceivergeneratesRFenergy,itcan cause interference to such equipment.• TurnOFFyourtransceiverwheresignsarepostedtodoso.Hospitalsandhealthcarefacilitiesuseequipment that is sensitive to electromagnetic radiation.• TurnOFFyourtransceiverwhileonboardanaircraftwhensoinstructed.Useofthetransceivermust be in accordance with airline regulations and/or crew instructions.

Navigation menu