INS Global S3-P RFID card reader User Manual instrucitonmenu

INS Global Pty Ltd RFID card reader instrucitonmenu

User manual

Model Name: S1,B1 etcProduct PictureWiring :Red: Power 5-16VBlack: Power groundGreen: Wiegand output D0White: Wiegand output D1Yellow: BuzzerOrange: LED Specification:Power requirementSupport cardInterfaceRead rangeFrequencyOperating temperatureOperating humidityAudio/Visual IndicationResponse TimeCable lengthWeightBuzzer control lineGreen LED control linewhen this control line is actived to lower by access controller host or connect to Ground line, buzzer will keppringing untill the line is released.when it is actived by access controller host or connect to ground line, Green LED will keep lighting untill the lineis released.5-16VDC at 100mA, A linear regulator is recommendedLess than 0.2 seconds 5 - 10 cm125.62KHz , 13.56M-30°C to +60°CLED function: The LED color is normally in RED. It starts with green flashe and will keep RED. When card isdetected successful, LED will flash green momentarily,this indicates cards were read properly . When LEDcontrol signal is actived by access controller host, LED will changes to green.Beeper Function: When Power up the reader, Beeper will ring 2 times. When cards is detected successful, ashort beep will be emitted. This indicates that HID card was read properly.INS serial 13.56M + 125k card reader125K card reader and also 13.56MHz dual frequency card readers. INS serial productsare in different case but with same hardware in one set PCBA. It reads 13.56M mifare cardand 125K HID compitable cards, and with wiegand interface or RS485 as per customer'srequest.Weigand250mm100-200gram per different modelLED/Buzzer function description125K or 13.56M proximity cards and fobtags.5%-95% (non-condensing)Green & Red and Buzzer signal output
Federal Communications Commission (FCC) Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ●Reorient or relocate the receiving antenna. ●Increase the separation between the equipment and receiver. ●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ●Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications made to this device not expressly approved by INS Global Pty Ltd may void the FCC authorization to operate this device. Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

Navigation menu