Hitron TECHNOLOGIES CODA4782 DOCSIS 3.1 wifi Gateway User Manual

Hitron Technologies Inc. DOCSIS 3.1 wifi Gateway Users Manual

Contents

Users Manual

QUICK START GUIDEHITRON CODA-4582/ 4682/ 4782Connect to the networkSet up your wireless networkRead mefirst!1STEPCheck the Box ContentsLook in the box and make sure you have the following:2STEPConnect to a Cable OutletUse a coaxial cable (not included) to connect the device’s CABLE connector to a cable outlet.3STEPConnect to a Power OutletUse the power cord provided to connect the POWER port to a power outlet.5STEP4STEPUser Configuration (Optional)QUICK START GUIDECODA-4582/4682/ 4782 ETHERNET CABLEPOWER CORDThe Hitron CODA-4582/ 4682/ 4782 is an application gateway that provides wired and wireless high-speed Internet access as well as optional MoCA (Multimedia over Coax Alliance) networking to the Ethernet-enabled devices in your home for a fast and easy home entertainment network.Use the Ethernet cable provided to connect one of the LAN ports to an Ethernet-equipped device.Connect to an Ethernet-Equipped Device (Optional)Setup CompleteIn a web browser, enter 192.168.0.1 in the address bar followed by Username and Password, as below.cusadminpassword7STEP Congratulations! You have successfully set up your CODA-4582/4682/ 4782. If you have any problems, see the section below for help in identifying the cause.IP AddressesIf the CODA-4582 is successfully connected to the network (see LED Display) but you cannot access the Internet from a connected computer, your computer’s IP Address may be set up improperly. In your computer’s network settings, ensure that it is configured to either receive an IP address automatically (recommended) or that it has a static IP address in the 192.168.0.10~192.168.0.254 range. For more information, consult your operating system’s Help documentation.Connect with Wireless Devices (Optional)6STEP Connect your wireless devices with the correct SSID and Passphrase. If you have not changed them, the default values are indicated on the sticker on the back of the unit.Connect your wireless devices with the WiFi Protected Setup (WPS). Access the configuration interface (see step 5), enter the Wireless page to enable WPS and set Encrypt Mode to AES, then press Save Changes. Press this button to begin the WPS Push-Button Configuration (PBC) procedure. Press the PBC button on your wireless clients in the coverage area within two minutes to enable them to join the wireless network.

Navigation menu