Hewlett Packard Enterprise APIN0207 Wireless Access Point User Manual 207 Series RCSI Guide Rev03

Aruba Networks, Inc. Wireless Access Point 207 Series RCSI Guide Rev03

Contents

User Manual Warning

Aruba 207 Series Wireless Access Point Regulatory Compliance and Safety Information Guide0511889-03 | September 2016 1IntroductionThis document contains domestic and international regulatory compliance and safety information for the access point. To ensure that this device complies with the regulatory standards for your region, please refer to the sections below.Electrical and Environmental SpecificationsRegulatory InformationProper Disposal of Aruba EquipmentElectrical and Environmental SpecificationsFor additional specifications on this product, please refer to the product data sheet at www.arubanetworks.com.ElectricalEthernet:One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45)Power:Maximum power consumption (excluding USB):13.5W (PoE) or 12W (DC)Direct DC source: 12Vdc nominal, +/- 5%Power over Ethernet (PoE): 802.3af complaint sourceConnect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.EnvironmentalOperating:Temperature: 0°C to +40°C (+32°F to +104°F)Humidity: 5% to 93% non-condensingStorage and transportTemperature: -40°C to +70°C (40°F to +158°F)Regulatory InformationThe following regulatory model names apply to the 207 Series access points:AP-207/IAP-207: APIN0207Aruba provides a multi-language document that contains country-specific restrictions and additional safety and regulatory information for all Aruba access points. This document can be viewed or downloaded from the following location: www.arubanetworks.com/safety_addendum.All Aruba access points should be professionally installed by an Aruba Certified Mobility Professional (ACMP). The installer is responsible for ensuring that grounding is available and meets applicable national and electrical codes.Tous les points d'accès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier doit s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur.If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL listed, without an output rated 12Vdc, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into a standard power receptacle in the US and Canada.

Navigation menu