HID Global 0006A Proximity Reader User Manual 5395 902 manual

HID Global Corporation Proximity Reader 5395 902 manual

Contents

5395 902 manual

REV DESCRIPTION DATE APPROVEDD REVISED PER EO #E5395-15NOTE: Cover sheet is for Revision Control only, and is not to be sent with document.REVSHEET 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 59 50 51REVSHEET 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33REV STATUS DDDDOF SHEETS 0123456789101112131415TOLERANCES APPROVALS DATE HID CORPORATION.XX = +/- .03” DWN E. DeQuiroz 081597 IRVINE, CALIFORNIA.XXX = +/- .010” CHK GRIFFIN 082297 Installation Manual,ANGLES = +/- 1°APVD OKUDA 082297 ThinLine II ReaderMATERIAL N/A APVD SIMPSON 082297FINISH N/A P/N 5395-902 REV DSCALE N/ATHIS DOCUMENT CONTAINS PROPRIETARYINFORMATION. IT MAY NOT BE DISCLOSED TOOTHERS OR USED FOR MANUFACTURINGPURPOSES WITHOUT THE PERMISSION OF HIDCORPORATION. SIZE A SHEET 0 OF 3
_____________________________________________________________________________________________________HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 1 of 3Install Manual – 5395-902 Rev DThinLine IITM Installation Manual
_____________________________________________________________________________________________________HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 2 of 3PARTS LIST (Included)Quantity- THINLINE IIM Reader with snap-on cover and 18”cable 1- #6-32 x 1” self-tapping panhead screw2- Installation manual 1PARTS LIST (Not-Included)Quantity- Wire splice 9- DC Power supply 5.0 VDC or 12 VDC2Mounting Instructions• Determine an appropriate mounting location. Thereader may be mounted to any surface, includingmetal.• Drill two (2) 3/32-inch (2.5mm) holes approximately1 inch deep for mounting the reader.• Drill a 5/8-inch (16mm) hole for the cable.• Remove the snap-on cover from the reader andsecure the reader to the mounting surface.• Route the cable from the reader and/or powersupply to the host. A linear type power supply isrecommended. Check all electrical codes for propercable installation.• For best operation, the drain wire should bedisconnected at the power supply end of the cables.• For the cable connection to the Panel - Use Alpha#1299C or equivalent.• Test the operation of the reader. After completion ofthe test, replace the snap-on cover.• See sheet 3 of this manual for the appropriatedimensioned drawings.Connecting the Reader to the HostConnect the reader to the host according to the wiringtable below and the host installation guide.WiegandClock & DataWire Color+DC+DCRedGroundGroundBlackData0DataGreenData1ClockWhiteShield GroundShield GroundDrainGreen LEDGreen LEDOrangeRed LEDRed LEDBrownBeeperBeeperYellowHoldHoldBlue---Card PresentVioletTesting and Operation
_____________________________________________________________________________________________________HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 3 of 3• When power is applied to the reader the LED willflash green three (3) times while the beeper beepssimultaneously. The LED will then turn red. Thisindicates that the microcontroller is operatingproperly.• Present an ID card to the reader. The LED willmomentarily turn green while the beeper beepsonce, indicating that the card was read successfully.Important Product SpecificationsPower requirements (linear supply)Operating Voltage Range 5.0 – 16.0 VDCAbsolute Maximum Voltage 18 VDCPeak Current 80 MaAverage Current 5V or 12V 20 MaMaximum cable distance 500 ft (153 m)To hostFCC Compliance Statement: This device complies withpart 15 of the FCC rules. Operation is subject to thefollowing two conditions: (1) this device may not causeharmful interference, and (2) this device must acceptany interference received, including interference thatmay cause undesired operation.
_____________________________________________________________________________________________________HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 4 of 3Front, side, and back viewFigure 1

Navigation menu